Analysis of solar water desalination using hybrid nanofluids: An experimental study

Analysis of solar water desalination using hybrid nanofluids: An experimental study

The performance characteristics of a novel solar water desalination system has been inves-tigated experimentally. The desalination unit consisted of a square basin-pyramid solar still coupled with a solar heater. Different DI water based mono and hybrid nanofluids were pre-pared using CuO and GO nanoparticles following the two-step method. DI water when em-ployed as the heat transfer fluid in the system, improved the distillate water yield by about 28.80% relative to the conventional solar still. Out of all the considered CuO mono-nano-fluids, the 1.0 wt.% concentration resulted in the maximum increment of about 78.80% in the distillate water yield followed by 1.5 wt.% (62.05%) and 0.5 wt.% (53.30%) respectively. Utilizing the CuO+GO hybrid nanofluid, resulted in maximum increment of about 127.46% at 25:75 nanoparticle proportion followed by, 50:50 (101.33%) and 75:25 (89.30%) respectively, while employing the 1.0 wt.% GO mono-nanofluid, resulted in an increment of about 54.93% in the distillate water yield. The pumping power of the prepared nanofluids was found to be the function of their concentration. Hence, the performance index was evaluated for all the tested heat transfer fluids followed by an economic analysis of all the considered cases. The pu-rity of the produced distilled water was also assessed by comparing with the Bureau of Indian Standards. Finally, the study proposed the best suitable heat transfer fluid for the investigated system and suggested the possible futuristic research objectives.

___

  • REFERENCES
  • [1] Damkjaer S, Taylor R. The measurement of water scarcity: Defining a meaningful indicator. Ambio 2017;46:513–531. [CrossRef]
  • [2] Chen X, Shuai C, Wu Y, Zhang Y. Understanding the sustainable consumption of energy resources in global industrial sector: Evidences from 114 countries. EIA Review 2021;90:106609. [CrossRef]
  • [3] Abdelgaied M, Kabeel AE, Kandeal AW,Abosheiasha HF, Shalaby SM, Hamed MH,et al. Performance assessment of solar PV-driven hybrid HDH-RO desalination system integrated with energy recovery units and solar collectors:Theoretical approach. Energy Conv Manag 2021;239:114215. [CrossRef]
  • [4] Shoeibi S, Rahbar N, Esfahlani AA, Kargarsharifabad H. A comprehensive review of Enviro-Exergo-economic analysis of solar stills. Renew Sustain Energy Rev 2021;149:111404. [CrossRef]
  • [5] Alawee WH, Essa FA, Mohammed SA, Dhahad HA, Abdullah AS, Omara ZM, et al. Improving the performance of pyramid solar distiller using dangled cords of various wick materials: Novel working mechanism of wick. Case Stud Therm Eng 2021;28:101550. [CrossRef]
  • [6] Essa FA, Alawee WH, Mohammed SA, Abdullah AS, Omara ZM. Enhancement of pyramid solar distiller performance using reflectors, cooling cycle, and dangled cords of wicks. Desalination 2021;506:115019. [CrossRef]
  • [7] Hansen RS, Munaf AA, Allasi HL, Endro S, Leno J, Kanna SKR. Experimental and theoretical optimization of an inclined type solar still using PV sustainable recirculation technique. Mater Today Proc 2021;45:7063–7071. [CrossRef] de Paula ACO, Ismail KAR. Comprehensive investigation of water film thickness effects on the heat and mass transfer of an inclined solar still. Desalination 2021;500:114895. [CrossRef]
  • [8] Elmaadawy K, Kandeal AW, Khalil A, Elkadeem MR, Liu B,Sharshir SW. Performance improvement of double slope solar still via combinations of low cost materials integrated with glass cooling. Desalination 2021;500:114856. [CrossRef]
  • [9] Parsa SM, Yazdani A, Dhahad H, Alawee WH, Hesabi S, Norozpour F, et al. Effect of Ag, Au, TiO2 metallic/metal oxide nanoparticles in double-slope solar stills via thermodynamic and environmental analysis. J Clean Prod 2021;311:127689. [CrossRef]
  • [10] Toosi SSA, Goshayeshi HR, Heris SZ. Experimental investigation of stepped solar still with phase change material and external condenser. J Energy Storage 2021;40:102681. [CrossRef]
  • [11] Elsheikh AH, Katekar VP, Muskens OL, Deshmukh SS, Elaziz MA, Dabour SM. Utilization of LSTM neural network for water production forecasting of a stepped solar still with a corrugated absorber plate. Process Saf Environ Prot 2021;148:273–282. [CrossRef]
  • [12] Shoeibi S, Rahbar N, Esfahlani AA, Kargarsharifabad H. A review of techniques for simultaneous enhancement of evaporation and condensation rates in solar stills. Sol Energy 2021;225:666–693. [CrossRef]
  • [13] Attia MEH, Kabeel AE, Abdelgaied M, Shmouty AR. Enhancing the hemispherical solar distiller performance using internal reflectors and El Oued sand grains as energy storage mediums. Environ Sci Pollut Res 2021;29:21451–21464. [CrossRef]
  • [14] Khalilmoghadam P, Rajabi-Ghahnavieh A, Shafii MB. A novel energy storage system for latent heat recovery in solar still using phase change material and pulsating heat pipe. Renew Energy 2021;163:2115–2127. [CrossRef]
  • [15] Younes MM, Abdullah AS, Essa FA, Omara ZM, Amro MI. Enhancing the wick solar still performance using half barrel and corrugated absorbers. Process Saf Environ Prot 2021;150:440–452. [CrossRef]
  • [16] Tuly SS, Rahman MS, Sarker MRI, Beg RA. Combined influence of fin, phase change material, wick, and external condenser on the thermal performance of a double slope solar still. J Clean Prod 2021;287:125458. [CrossRef]
  • [17] Amiri H, Aminy M, Lotfi M, Jafarbeglo B. Energy and exergy analysis of a new solar still composed of parabolic trough collector with built-in solar still. Renew Energy 2021;163:465–479. [CrossRef]
  • [18] Nazari S, Safarzadeh H, Bahiraei M. Performance improvement of a single slope solar still by employing thermoelectric cooling channel and copper oxide nanofluid: An experimental study. J Clean Prod 2019;208:1041–1052. [CrossRef]
  • [19] Shoeibi S, Rahbar N, Esfahlani AA, Kargarsharifabad H. Improving the thermoelectric solar still performance by using nanofluids– Experimental study, thermodynamic modeling and energy matrices analysis. Sustain Energy Technol Assess 2021;47:101339. [CrossRef]
  • [20] Abdelgaied M, Zakaria Y, Kabeel AE, Essa FA. Improving the tubular solar still performance using square and circular hollow fins with phase change materials. J Energy Storage 2021;38:102564. [CrossRef]
  • [21] Abdelaziz GB, Algazzar AM, El-Said EMS, Elsaid AM, Sharshir SW, Kabeel AE,et al. Performance enhancement of tubular solar still using nano-enhanced energy storage material integrated with v-corrugated aluminum basin, wick, and nanofluid. J Energy Storage 2021;41:102933. [CrossRef]
  • [22] Abdelgaied M, Attia MEH, Kabeel AE, Zayed ME. Improving the thermo-economic performance of hemispherical solar distiller using copper oxide nanofluids and phase change materials: Experimental and theoretical investigation. Sol Energy Mater Sol Cells 2022;238:111596. [CrossRef]
  • [23] Shoeibi S, Kargarsharifabad H, Rahbar N, Ahmadi G, Safaei MR. Performance evaluation of a solar still using hybrid nanofluid glass cooling-CFD simulation and environmental analysis. Sustain Energy Technol Assess 2022;49:101728. [CrossRef] Rabbi HMF, Sahin AZ. Performance improvement of solar still by using hybrid nanofluids. J Therm Anal Calorim 2021;143:1345–1360. [CrossRef]
  • [24] Essa FA, Alawee WH, Mohammed SA, Dhahad HA, Abdullah AS, Omara ZM. Experimental investigation of convex tubular solar still performance using wick and nanocomposites. Case Stud Therm Eng 2021;27:101368. [CrossRef]
  • [25] Thakur AK, Sathyamurthy R, Velraj R, Saidur R, Hwang JY. Augmented performance of solar desalination unit by utilization of nano-silicon coated glass cover for promoting drop-wise condensation. Desalination 2021;515:115191. [CrossRef]
Journal of Thermal Engineering-Cover
  • Başlangıç: 2015
  • Yayıncı: YILDIZ TEKNİK ÜNİVERSİTESİ
Sayıdaki Diğer Makaleler

Determination of optimum insulation thickness in submarines

Savaş DURMAZ, Andaç Batur ÇOLAK, Hatice MERCAN, Ahmet Selim DALKILIÇ

Insight of boundary layer structure with heat transfer through a diverging porous channel in Darcy-Forchheimer porous material with suction/injection: A study of separation control

Astick BANERJEE, Sanat Kumar MAHATO, Krishnendu BHATTACHARYYA, Sohita RAJPUT, Ajeet Kumar VERMA, Ali J. CHAMKHA

Single-phase and two-phase models of a hybrid nanofluid traveling through a non-uniformly heated (PTC) receiver: A comparative study

Amina BENABDERRAHMANE, Ahmed Kadhim HUSSEIN, Obai YOUNIS, Abdelylah BENAZZA

Experimental study on heat transfer from rectangular fins in combined convection

Mehdi BASIRI, Hamid Reza GOSHAYESHI, Issa CHAER, Hadi POURPASHA, Saeed Zeinali HERIS

Flow field and heat transfer of ferromagnetic nanofluid in presence of magnetic field inside a corrugated tube

Aram Soleimani VARKANEH, Ghanbar Ali SHEIKHZADEH NOOSHABADI, Ali Akbar Abbasian ARANİ

Heat transfer enhancement of electronic devices by using flexible printed circuit boards

Mustafa EMAD, Sattar ALJABAIR, Ahmed Abdulnabi IMRAN

Mathematical modelling of evaporation rate and heating of biodiesel blends of a single-component droplets

Madan BASNET, D. SENTHILKUMAR, R. YUVARAJ

The evaluation of the performance of the heat exchanger of a triple concentric tube configuration with ionic liquid (imidazolium) and MWCNT ionanofluid

Huda Majid HASAN, Basma Abbas ABDULMAJEED

Geometric modification and placement of high heat flux ic chips on substrates of different materials for enhanced heat transfer

Shankar DURGAM, Ajinkya BHOSALE, Vivek BHOSALE

Numerical simulation to study mixing vane spacer effects on heat transfer performance of supercritical pressure fluid in an annular channel

Satish Kumar DHURANDHAR, Shobha Lata SINHA, Shashi Kant VERMA