Mehdi BASIRI, Hamid Reza GOSHAYESHI, Issa CHAER, Hadi POURPASHA, Saeed Zeinali HERIS

Experimental study on heat transfer from rectangular fins in combined convection

Combined natural and forced convective heat transfer arise in many transport processes in engineering devices and in nature, which is frequently encountered in industrial and technical processes, including electronic devices cooled by fans, heat exchangers placed in a low-ve-locity environment, and solar receivers exposed to winds. In this study, the effects of design parameters have been experimentally investigated for the air-side thermal performance under combined (natural and forced) convection of the rectangular plate heat sinks, and the values of optimum design parameters were sought. Many ideas for improving cooling methods have been proposed, one of which is the heat sink. In this work, the average Nusselt number (Nu) and thermal resistance of a simple base rectangular plate and five vertical rectangular plate heat sinks with different numbers of fins under natural and combined convection were exper-imentally investigated to obtain the maximum average Nu and minimum thermal resistance for various Reynolds numbers (Re) from 2300 to 40000, Rayleigh numbers (Ra) from 1300000 to 13000000, and Richardson numbers (Ri) from 0.4 to 3. Also, in this experiment, fin spacing (P) was varied from 2.8 mm to 14.6 mm and the dimensionless P/H ratio was varied from 0.1 to 0.49. The flow velocity varied in the range of 2 to 8 m/s under combined convection. Based on the effects of Ri and Re, two empirical equations for natural and also for combined con-vection heat transfer were derived to calculate the average Nu. The average deviation for these two equations is about 7%. The outcomes of this research can be beneficial for engineers who work on electronics cooling systems.

Keywords:

Plate Heat Sink, Combined Convection, Rectangular Fin, Richardson Number, Empirical Equation,

PDF

___

REFERENCES
Pourpasha H, Heris SZ, Mohammadpourfard M. The effect of TiO2 doped multi-walled carbon nanotubes synthesis on the thermophysical and heat transfer properties of transformer oil: A comprehensive experimental study. Case Stud Ther Eng 2023;41:102607. [CrossRef]
Kargaran M, Goshayeshi HR, Pourpasha H, Chaer I, Heris SZ. An extensive review on the latest developments of using oscillating heat pipe on cooling of photovoltaic thermal system. Ther Sci Eng Prog 2022;1:101489. [CrossRef] Emamifar A, Moghadasi H, Noroozi MJ, Saffari H. Transient analysis of convective-radiative heat transfer through porous fins with temperature-dependent thermal conductivity and internal heat generation. J Therm Eng 2021;8:656-666. [CrossRef]
Krishnayatra G, Tokas S, Kumar R, Zunaid M. Parametric study of natural convection showing effects of geometry, number and orientation of fins on a finned tube system: A numerical approach. J Therm Eng 2021;8:268285. [CrossRef]
Zolfalizadeh M, Zeinali Heris S, Pourpasha H, Mohammadpourfard M, Meyer JP. Experimental Investigation of the Effect of Graphene/Water Nanofluid on the Heat Transfer of a Shell-and-Tube Heat Exchanger. Int J Energy Res 2023;2023:3477673. [CrossRef]
Barai R, Kumar D, Wankhade A. Heat transfer performance of nanofluids in heat exchanger: a review. J Therm Eng 2021;9:86106. [CrossRef]
Kobus CJ, Oshio T. An experimental and theoretical investigation into the thermal performance characteristics of a staggered vertical pin fin array heat sink with assisting mixed convection in external and in-duct flow configurations. Exp Heat Transf 2006;19:129148. [CrossRef]
Kobus CJ, Oshio T. Development of a theoretical model for predicting the thermal performance characteristics of a vertical pin-fin array heat sink under combined forced and natural convection with impinging flow. Int J Heat Mass Transf 2005;48:10531063. [CrossRef]
Haghighi SS, Goshayeshi HR, Safaei MR. Natural convection heat transfer enhancement in new designs of plate-fin based heat sinks. Int J Heat Mass Transf 2018;125:640647. [CrossRef]
Yang MH, Yeh RH, Hwang JJ. Mixed convective cooling of a fin in a channel. Int J Heat Mass Transf 2010;53:760771. [CrossRef]
Li HY, Chao SM. Measurement of performance of plate-fin heat sinks with cross flow cooling. Int J Heat Mass Trans 2009;52:29492955. [CrossRef]
Wang Y, Liu Y, Wang X, Zhao Q, Ke Z. Experimental study on the heat transfer and resistance characteristics of pin-fin tube. Therm Sci 2021;25:5972. [CrossRef] Yeom T, Simon T, Zhang M, Yu Y, Cui T. Active heat sink with piezoelectric translational agitators, piezoelectric synthetic jets, and micro pin fin arrays. Exp Therm Fluid Sci 2018;99:190199. [CrossRef]
Xu Y, Gong L, Li Y, Bai Z, Xu M. Thermal performance and mechanics characteristic for double layer microchannel heat sink. J Therm Sci 2019;28:271282. [CrossRef]
Balasubramanian KR, Krishnan RA, Suresh S. Spatial orientation effects on flow boiling performances in open microchannels heat sink configuration under a wide range of mass fluxes. Exp Therm Fluid Sci 2018;99:392406. [CrossRef]
Gaikwad VP, Mohite SS. Performance analysis of microchannel heat sink with flow disrupting pins. J Therm Eng 2022;8:402425. [CrossRef]
Gandikota V, Jones GF, Fleischer AS. Thermal performance of a carbon fiber composite material heat sink in an FC-72 thermosyphon. Exp Therm Fluid Sci 2010;34:554561. [CrossRef]
Muhammed MA, Al-Hamadani AA. Study of the performance of multiple v-type fin arrangements as an enhancement of natural heat transfer from a vertical surface. J Phys Conf Ser 2021;1773:012015[CrossRef]
Ma CF, Gan YP, Tian YQ, Lei DH. Fundamental research on convective heat transfer in electronic cooling technology. J Therm Sci 1992;1:3040. [CrossRef]
Wu W, Soliman H. Performance analysis and optimization of rectangular fin arrays used in plate-fin heat exchangers. Therm Sci 2021;25:34793491. [CrossRef]
Shim M, Ha MY, Min JK. A numerical study of the mixed convection around slanted-pin fins on a hot plate in vertical and inclined channels. Int Comm Heat Mass Transf 2020;118:104878. [CrossRef]
Mohammed AA, Razuqi SA. Performance of rectangular pin-fin heat sink subject to an impinging air flow. J Therm Eng 2021;7:666676. [CrossRef]
Mohammed AA, Razuqi SA. Effect of air fan position on heat transfer performance of elliptical pin fin heat sink subjected to impinging air flow. J Therm Eng 2021;7:14061416. [CrossRef]
Xu Y, Gong L, Li Y, Bai Z, Xu M. Thermal performance and mechanics characteristic for double layer microchannel heat sink. J Therm Sci 2019;28:271282. [CrossRef]
Rebay M, Arfaoui A, Padet J, Ben Maad R. Experimental study of the effects of a transversal air-flow deflector in electronics air-cooling. J Therm Sci 2011;20:7681. [CrossRef]
El-Sayed SA, Mohamed SM, Abdel-latif AA, Abdel-hamid EA. Experimental study of heat transfer and fluid flow in longitudinal rectangular-fin array located in different orientations in fluid flow. Exp Therm Fluid Sci 2004;29:113128. [CrossRef]
Wani SA, Shrotri AP, Dandekar AR. Experimental Investigation of Natural Convection Heat Transfer from a Fin Array-A Review. Int J Mod Stud Mech Eng 2016;2:4650.
Ji C, Qin Z, Low Z, Dubey S, Choo FH, Duan F. Non-uniform heat transfer suppression to enhance PCM melting by angled fins. Appl Therm Eng 2018;129:269279. [CrossRef]
El-Hakim N, Assaf J, Nehme B, Zeghondy B, Said W, Jelwan J. CFD analysis andheat transfer characteristics of printed circuit heat exchanger. J Therm Eng 2021;8:335348. [CrossRef]
Huang Y, Shen S, Li H, Gu Y. Numerical analysis on the thermal performances of different types of fin heat sink for high-power led lamp cooling. Therm Sci 2019;23:625636.
Feng S, Li F, Zhang F, Lu TJ. Natural convection in metal foam heat sinks with open slots. Exp Therm Fluid Sci 2018;91:354362. [CrossRef]
Nemati M, Sefid M. Using active/passive methods to control of MHD conjugate heat transfer of power-law fluids: a numerical entropy analysis by LBM. Int J Energy Environ Eng 2022;14:123. [CrossRef]
Ming Z, Zhongliang L, Guoyuan M, Shuiyuan C. The experimental study on flat plate heat pipe of magnetic working fluid. Exp Therm Fluid Sci 2009;33:11001105. [CrossRef]
Soodmand AM, Nejatbakhsh S, Pourpasha H, Aghdasinia H, Heris SZ. Simulation of melting and solidification process of polyethylene glycol 1500 as a PCM in rectangular, triangular, and cylindrical enclosures. Alex Eng J 2022;61:84318456. [CrossRef]
Yoon Y, Kim DR, Lee KS. Cooling performance and space efficiency improvement based on heat sink arrangement for power conversion electronics. Appl Therm Eng 2020;164:114458. [CrossRef]
Li HY, Tsai GL, Chao SM,Yen YF. Measurement of thermal and hydraulic performance of a plate-fin heat sink with a shield. Exp Therm Fluid Sci 2012;42:7178. [CrossRef]
Singh P, Patil AK. Experimental investigation of heat transfer enhancement through embossed fin heat sink under natural convection. Exp Therm Fluid Sci 2015;61:2433. [CrossRef]
Mithun CN, Hasan MJ, Azad AK, Hossain R, Rahman MM. Effect of unsteady relative thermal and concentration boundary layer thickness on mixed convection in a partially heated contaminated enclosure. S Afr J Chem Eng 2022;42:201215. [CrossRef]
Bergman TL, Lavine AS, Incropera FP, DeWitt DP. Introduction to heat transfer.7th ed. Hoboken: John Wiley & Sons; 2011
Alizadeh H, Pourpasha H, Heris SZ, Estellé P. Experimental investigation on thermal performance of covalently functionalized hydroxylated and non-covalently functionalized multi-walled carbon nanotubes/transformer oil nanofluid. Case Stud Therm Eng 2022;31:101713. [CrossRef]
Holman JP. First Order Systems. Experimental Methods for Engineers.7th ed. New York: McGraw-Hill; 2005. p.1923.
Dou HS, Jiang G, Zhang L. A numerical study of natural convection heat transfer in fin ribbed radiator. Math Probl Eng 2015;2015:989260. [CrossRef]
Ayli E, Bayer O, Aradag S. Experimental investigation and CFD analysis of rectangular profile FINS in a square channel for forced convection regimes. Int J Therm Sci 2016;109:279290. [CrossRef]
Harris DC. Nonlinear least-squares curve fitting with Microsoft Excel Solver. J Chem Educ 1998;75: 119121. [CrossRef]