Huda Majid HASAN, Basma Abbas ABDULMAJEED

The evaluation of the performance of the heat exchanger of a triple concentric tube configuration with ionic liquid (imidazolium) and MWCNT ionanofluid

In this study, a triple concentric tube heat exchanger (TCTHE) was designed. It had three copper concentric tubes. Their thicknesses were 0.762 mm, 1.143 mm, and 1.27 mm. The diameters were 9.525 mm, 22.25 mm, and 34.925 mm, respectively. The tube’s length was 670 mm. The cooling medium used was the ionic-liquid (IL) 1-Ethyl-3-methylimidazoliumtetra-flouraborate [EMIM][BF4] and the ionanofluid (INF) prepared of 0.5% Multi walled carbon nanotubes (MWCNT) in [EMIM][BF4], while oil forty stock was the hot fluid, to investigate TCTHE performance. The volumetric flow rate (VFR) of the cooling medium was 20-55 l/hr, with a 25-27 °C temperature (temp). VFR of the hot fluid was constant and equal 20 l/hr. The inlet oil temp was 50, 60, and 70 oC, respectively. The type of flow was countercurrent. The heat transfer was investigated by calculating different parameters for the cooling medium. There was an improvement in the Nusselt number (NU) of INF of 5% compared to the IL. A 75% increase in the friction factor of INF was found compared to that of IL. A 95% increase in the pressure drop was calculated in the inner tube using INF compared with that of IL. The overall heat transfer coefficient (U) was enhanced by 3% using INF in comparison with IL. Fi-nally, U showed some improvement, resulting in increased heat transfer. In conclusion, using the prepared INF lead to improve the heat transfer in the TCTHE.

Keywords:

[EMIM][BF4], Friction Factor, Ionic Liquid, Ionanofluid, Mwcnts, Nusselt Number, Overall Heat Transfer Coefficient Pressure Drop, Triple Concentric Heat Exchanger,

PDF

___

REFERENCES
[1] Welton T. Ionic liquids: a brief history. Biophys Rev 2018;10:691706. [CrossRef]
[2] Santos D, Santos M, Franceschi E, Dariva C, Barison A, Mattedi S. Experimental density of ıonic liquids and thermodynamic modeling with group contribution equation of state based on the lattice fluid theory. J Chem Eng Data 2016;61:348353. [CrossRef]
[3] Shukla M, Saha S. A comparative study of piperidinium and imidazolium based Ionic Liquids: Thermal, spectroscopic and theoretical studies. In: Kadokawa JI, editor. Ionic Liquids - New Aspects for the Future. London: Intechopen; 2013. p.1–25. [CrossRef]
[4] Zhang S, Sun N, He X, Lu X, Zhang XP. Physical properties of ionic liquids: database and evaluation. J Phys Chem Ref Data 2006;35:1475–517. [CrossRef]
[5] Nieto de Castro CA, Lourenço MJV, Ribeiro APC, Langa E, Vieira SIC, Goodrich P, et al. Thermal properties of ionic liquids and IoNanoFluids of imidazolium and pyrrolidinium liquids. J Chem Eng Data 2010;55:653661. [CrossRef]
[6] Wen D, Ding Y. Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions. Int J Heat Mass Transf 2004;47:51815188. [CrossRef]
[7] Zamzamian SA, Nasseri Oskouie S, Doosthoseini A, Joneidi Jafari A, Pazouki M. Experimental investigation of forced convective heat transfer coefficient in nanofluids of Al2O3/EG and CuO/EG in a double pipe and plate heat exchangers under turbulent flow. Exp Therm Fluid Sci 2011;35:495502. [CrossRef]
[8] Albadr J, Tayal S, Khasaal MT. Heat transfer through heat exchanger using Al2O3 nanofluid at different concentrations. Case Stud Therm Eng 2013;1:3844. [CrossRef]
[9] Ezzat A, Hasan IM. Investigation of alumina nano fluid thermal conductivity. Int J Comput Appl 2014;102:1523. [CrossRef]
[10] Chavda NK, Jani JP, Patel AK, Zala KP, Nimbark NG. Effect of nanofluid on friction factor of pipe and pipe fittings: Part I-effect of aluminum oxide nanofluid. Int J Curr Eng Technol 2014;4:4069–4074.
[11] Chavda NK. Effect of nanofluid on heat transfer characteristics of double pipe heat exchanger: part-II: effect of copper oxide nanofluid. Int J Res Eng Technol 2015;4:688– 696. [CrossRef]
[12] Sudarmadji S. A new correlation for pressure drop in the cooling process of Al2O3-water nanofluid in pipes. FME Trans 2015;43:40–46. [CrossRef]
[13] Abdulmajeed BA, Majeed NS. Study and analysis of concentric shell and double tube heat exchanger using γ-Al2O3 nanofluid. J Eng 2017;23:50–62. [CrossRef]
[14] Pillai PS, Mohan R, Sasidharan S, Venkatesh K. Study on concentric tube heat exchanger with different nano fluids for enhancing the heat transfer: A review. Imp J Interdiscip Res 2017;3:682–638.
[15] Shirgire ND, Bhansali SS, Bhagat AR, Padgelwar AG, Ghawade PS. Influence of Ionic Fluid in counter flow in shell and tube heat exchanger. Int J Eng Trends Technol 2014;13:55– 58. [CrossRef]
[16] Jikar PC, Bondre A, Patil A, Korpe S. Heat transfer enhancement in shell and tube heat exchanger by using Ionic fluid (BMIMCL). Int J Mech Prod Eng 2018;6:114.
[17] Palanisamy K, Mukesh Kumar PC. Experimental investigation on convective heat transfer and pressure drop of cone helically coiled tube heat exchanger using carbon nanotubes/water nanofluids. Heliyon 2019;5:e01705. [CrossRef]
[18] Poongavanam GK, Kumar B, Duraisamy S, Panchabikesan K, Ramalingam V. Heat transfer and pressure drop performance of solar glycol / activated carbon based nano fluids in shot peened double pipe heat exchanger. Renew Energy 2019;140:580–591. [CrossRef]
[19] Logesh K, Baskar S, Siddarth BY, Sherwin KA, Naresh P. Multi-walled carbon nanotube mixed with isopropyl alcohol Nano fluid for heat transfer applications. Mater Today Proc 2019;18:46904694. [CrossRef]
[20] Nasirzadehroshenin F, Sadeghzadeh M, Khadang A, Maddah H, Ahmadi MH, Sakhaeinia H, et al. Modeling of heat transfer performance of carbon nanotube nanofluid in a tube with fixed wall temperature by using ANN – GA. Eur Phys J Plus 2020;123:217. [CrossRef]
[21] Zuritz CA. On the design of triple concentric-tube heat exchangers. J Food Process Eng 1990;12:113–130. [CrossRef]
[22] Saeid N, Seetharamu KN. Finite element analysis for co‐current and countercurrent parallel flow three-fluid heat exchanger. Int J Numer Methods Heat Fluid Flow 2006;16:324–337. [CrossRef]
[23] Quadir GA, Jarallah SS, Ahmed NJS, Badruddin IA. Experimental investigation of the performance of a triple concentric pipe heat exchanger. Int J Heat Mass Transf 2013;62:562–566. [CrossRef]
[24] Quadir GA, Badruddin IA, Ahmed NJS. Numerical investigation of the performance of a triple concentric pipe heat exchanger. Int J Heat Mass Transf 2014;75:165–172. [CrossRef]
[25] Hossain A, Uddin AF, RashelHossen, Afroz HMM. Experimental analysis of a triple concentric tube heat exchanger. Int J Mod Stud Mech Eng 2017;3:110.
[26] Pancholi M, Virani B. A basic review on triple concentric tube heat exchanger. Int J Adv Technol Eng Sci 2017;5:350–354.
[27] Sagar J, Prasad I, Deepak M. Review on triple tube heat exchanger with dimple on internal tube & internal threaded middle tube using CFD and Experimental analysis for heat transfer. J Inf Knowl Res Mech Eng 2017;4:796–798.
[28] Meikandan M, Kumar PG, Sundarraj M, Yogaraj D. Numerical analysis on heat transfer characteristics of ionic liquids in a tubular heat exchanger. Int J Ambient Energy 2020;41:911–917. [CrossRef]
[29] Hasen HM, Abdulmajeed BA. Thermophysical properties of [EMIM][BF4] and [HMIM][PF6] imidazolium ionic liquids with MWCNTs. In: IOP Conference Series: Materials Science and Engineering PAPER. London; 2020. [CrossRef]
[30] Hasen HM, Abdulmajeed BA. Theoretical investigation of the density and the heat capacity of [EMIM][ BF4] and its MWCNTs ionanofluids : Effect of temperature and MWCNTs concentration. J Phys Conf Ser 2021;2114:012036. [CrossRef]
[31] Ghiwala TM, Matawala VK. Sizing of triple concentric pipe heat exchanger. Int J Eng Dev Res 2014;2:1683–1692.
[32] Pirhayati M, Akhavan-Behabadi MA, Khayat M. Pressure drop of CuO-base oil nanofluid flow inside an inclined tube. Int J Adv Eng Technol 2012;5:122129.