Betonarme Binalarda Bölme Duvar Etkilerinin Tam Ölçekli Deneylerle Araştırılması

Bu çalışmada betonarme yapılarda bulunan bölme tuğla duvarların bina dinamik özelliklerine olan etkisi deneysel çalışmalarla belirlenmiştir. Çalışmada 1980’li yıllarda inşa edilmiş altı katlı betonarme bir bina deney numunesi olarak kullanılmıştır. Çalışılan binanın dinamik özellikleri çevresel titreşim analizleri ile belirlenmiştir. Daha sonra binanın zemin katında bulunan tuğla ve çimento harcıyla örülmüş bölme duvarlar doldurdukları çerçevelerden ayrılarak etkisizleştirilmiştir. Tekrarlanan çevresel titreşim analizleriyle, binanın zemin katında bölme duvarları olmaması durumunda dinamik özellikler belirlenmiştir. Çalışılan binanın iki hali için belirlenen dinamik özelliklerin karşılaştırılmasıyla bölme duvarların yapı dinamik davranışlarına olan katkıları belirlenmiştir. 

Investigation of Effects of Infill Walls in Reinforced Concrete Buildings with Full-Scaled Experiments

In this study, the effects of partition walls into dynamic behavior of reinforced concrete building are investigated with experimental researches. A six-story reinforced concrete building, constructed in 1980s, is used as a test specimen. The dynamic characteristics of the studied building are determined by ambient vibration survey. Later on the partition walls, composed of bricks and cement mortar, are set ineffective by separating them from the frames they fill. The repeated ambient vibration survey gives the dynamic characteristics of the building which does not have partition walls on its ground floor. The comparison of the determined dynamic characteristics for two forms of the same building revealed the contribution of partition walls into the dynamic properties of the building. 

___

  • Fiore, A., Netti, A., Monaco, P., The influence of masonry infill on the seismic behaviour of RC frame buildings, Engineering Structures, 44, 133–145, 2012.
  • Uva, G., Porco, F., Fiore, A., Appraisal of masonry infill walls effect in the seismic response of RC framed buildings: A case study, Engineering Structures 34, 514–526, 2012.
  • Köse, M. M. Parameters affecting the fundamental period of RC buildings with infill walls, Engineering Structures, 31, 93-102, 2009.
  • Mehrabi, A. B., Shing, P. B., Schuller, M. P., Noland, L., Experimental Evaluation of Masonry-Infilled RC Frames, J. Struct. Eng, 122(3), 228–237, 1996.
  • Zarnic, R., Gostic, S., Crewe, A. J., and Taylor, C. A., Shaking table tests of 1:4 reduced-scale models of masonry infilled reinforcedconcrete frame buildings, Earthquake Eng. Struct. Dyn., 30(6), 819–834, 2001.
  • Hashemi, A., and Mosalam, K. M., Shake-table experiment on reinforced concrete structure containing masonry infill Wall, Earthquake Eng. Struct. Dyn., 35(14), 1827–1852, 2006.
  • Çankaya, M. A., Dynamic Behavior of Reinforced Concrete Frames with Infill Walls, MASTER Thesis, İzmir Institute of Technology, İzmir, 2011.
  • Bayraktar, A., Türker, T., Altunışık, A. C., Sevim, B., Şahin, A., Özcan, D. M., Binaların Dinamik Parametrelerinin Operasyonal Modal Analiz Yöntemiyle Belirlenmesi. İMO Teknik Dergi, 5185-205, 2010.
  • Ewins, D. J., Modal Testing: Theory and Practice. John Wiley & Sons, New York, 1995.
  • Michel, C., Gueguen, P., and Bard, P.-Y., Dynamic parameters of structures extracted from ambient vibration measurements: An aid for the seismic vulnerability assessment of existing buildings in moderate seismic hazard regions, Soil Dynamics and Earthquake Engineering, 28, 593–604, 2008.
  • Guler, K., Yuksel, E., and Kocak, A., Estimation of the fundamental vibration period of existing RC buildings in Turkey utilizing ambient vibration records. J. Earthquake Eng., 12(S2), 140–150, 2008.
  • Soyoz, S., Taciroglu, E., Orakcal, K., Nigbor, R., Skolnik, D., Lus, H., Safak, E., Ambient and Forced Vibration Testing of a Reinforced Concrete Building before and after Its Seismic Retrofitting. J. Struct. Eng. 139:1741-1752, 2013.
  • ABYYHY, Afet Bölgelerinde yapılacak yapılar hakkında yönetmelik, T.C. İmar ve İskan Bakanlığı, Deprem Araştırma Enstitüsü Başkanlığı, Ankara, 1975.
  • Aras F., Frequency variation in construction stages and model validation for steel buildings, Steel and Composıte Structures, 22, 647-662, 2016.
  • Aras F., Ambient and forced vibration testing with numerical identification for RC buildings, Earthquakes and Structures, 11, 809-822, 2016.
  • Brincker, R., Ventura, C., and Andersen, P., “Why ouput-only modal testing is a desirable tool for a wide range of practical applications” In 21st international modal analysis conference (IMAC), Kissimmee, Florida, 2003.
  • Matlab, The MathWorks, Inc., Natick, Massachusetts, United States, 2012.
  • DBYBHY, Deprem Bölgelerinde Yapılacak Binalar Hakkında Esaslar. Bayındırlık ve İskan Bakanlığı, Türkiye, 2007.