A novel procedure and parameters for design of symmetric quantum wells in terms of normalised propagation constant as a model in the single mode

Bu çalışmada, kuantum çukurundaki elektron ve delikler gibi taşıyıcıların enerji öz değerlerine bağlı olan bazı tasarım parametreleri elde edilmiştir. Kuantum çukurunun hapsedici tabakaları ve aktif bölgesine ait bazı optik suç ifadeleri elde edilmiş ve teorik olarak hesaplanmıştır.

In this work, some design parameters have been obtained, depending on the energy eigenvalue of the carriers such as electrons and holes confined in the quantum well. Some optical power expressions for the active region and cladding layers of the quantum well have been obtained in terms of these parameters and have been theoretically estimated.

PDF

___

Patnaick, P.C. ve Thamburaj R., “Development of a Qualification Methodology for Advanced Gas Turbine Engine Repairs/Reworks”, NATO RTO Meeting Proceedings 17, Canada Communication Group Inc., Quebec, Canada, 11 p. (1999)
Irwin, E.T., “Aircraft Gas Turbine Engine Technology”, 2nd Ed., McGraw-Hill Book Co., UK (1979)
Rajurkar, K. P., Kozak J., ve Chatterjee, A., “Nonabrasive Finishing Methods”, ASM Handbook Volume 5 Surface Engineering, ASM International, USA, 110-116 (1996)
Phillips, R.E., “What Is Electrochemical Grinding and How Does It Work”, Nontraditional Conference Proceedings, ASM International, USA, 65-70 (1986)
HORNE, D.F., “Aircraft Production Technology”, Cambridge University Press, UK (1985)
McGeough, J. A., “Advanced Methods of Machining”, Chapman and Hall, USA (1988)
Rajurkar, K. P., Kozak J., ve Chatterjee, A., “Nonabrasive Finishing Methods”, ASM Handbook Volume 5 Surface Engineering, ASM International, USA, 110-116 (1996)
Stefan, D., “Manufacturing by Electrochemical and Spark Discharge Machining”, Department of Mechanical Engineering University of Bath, UK, htpp://www.bath.ac.uk (2001)
Rajurkar, K. P., “Electrochemical Machining”, University of Nebraska Nontraditional Research Center, US, htpp://www.unl.edu/nmrc (2001)
Lievestro, T.L., “Electrochemical Machining”, ASM Handbook Volume 16 Machining, ASM International, USA, 533-541 (1997)
Technical Description of ECM Components, US, http:// www. rose_hulman.edu (2001)
How ECM Works and Benefits of ECM, US, http://www.sermatec.com (2001)
Fuller, J.E., “Electrical Discharge Machining”, ASM Handbook Volume 16 Machining, ASM International, USA, 557-561 (1997)
Taeusch, D.R., “YAG Laser Processing In The Aircraft Industry”, Nontraditional Conference Proceedings, ASM International, USA, 79-95 (1986)
Dalkılıç, S., “Jet Motorlarına Uygulanan Parça Yenileme İşlemleri”, Yüksek Lisans Tezi, Anadolu Üniversitesi Fen Bilimleri Enstitüsü, Eskişehir, Türkiye (2001)
Hastings, R.R., “Aero-Engine Component Repair/Replacement Decision Factors”, NATO RTO Meeting Proceedings 17, Canada Communication Group Inc., Quebec, Canada, 6 p. (1999)