Microstructure and Scratch Resistance of Ceramic Surfaces

In order to gain a fundamental understanding of material removal mechanisms and damage morphology in brittle materials, such as ceramics, several studies using both static indentation and scratch test have been conducted. Since the 1980’s, it is known as the results of a scratch test provides information concerning the cracking of brittle materials, close to those induced by the indentation test, [1]. As regards, while hardness determination represents the result of a static indentation test, involving only a normal load applied to an indenter having different tip geometry (spherical, conical or pyramidal) and coming into contact with the surface of the material to be analysed, in the scratch test the normal load, LN, is applied to an indenter with the same geometry, but into contact with the surface of a moving sample. The effects induced on the surface of the sample by the combination of the normal and tangential loads, (LN and LT) overcoming, under definite conditions, the strength of the material, lead to an elastic-plastic deformation the effect of which is the formation of a scar.

Anahtar Kelimeler:

Microstructure, Scratch, Resistance

Microstructure and Scratch Resistance of Ceramic Surfaces

Keywords:

Microstructure, Scratch, Resistance,

PDF

___

A.G. Evans and D.B. Marshall: Wear Mechanisms in Ceramics. In “Fundamentals of Friction and Wear of Materials”, Ed. D.A. Rigney, American Society for Metals, Metals Park, Ohio 44073, 1981, 439-450.
International Standard ISO 20502: Fine ceramics, (Advanced ceramics, advanced technical ceramics) - Determination of adhesion of ceramic coatings by scratch testing. First edition 2005- 08-15. 3 J.C. Lambropoulos, S.D. Jacobs, and J. Ruckman: Material Removal Mechanisms from Grinding to Polishing. In “Finishing of Advanced Ceramics and Glasses” Eds. R. Sabia, V.A. Greenhut, C.G. Pantano, The American Ceramic Society, 735 Ceramic Place, Westerville, Ohio 43081, 1999, 113-128.
I.M. Hutchings, Y. Xu, E. Sánchez, M.J. Ibáñez, M.F. Quereda: Development of surface finish during the polishing of porcelain ceramic tiles. J. Mat. Sci., 40 (2005), 37-42.
L. Esposito, A. Tucci, D. Naldi: The reliability of polished porcelain stoneware tiles. J. Eur. Ceram. Soc., 25, 1487-1489, (2005).
A. Tucci, L. Esposito, L. Malmusi, A. Piccinini: Wear Resistance and Stain Resistance of Porcelain Stoneware Tiles. Key Engineering Materials Trans Tech Publications, Vols. 203-213, (2001), 1759-1762.
A. Tucci, L. Esposito, L. Malmusi, A. Piccinini: Surface deterioration and scratch resistance of polished porcelain stoneware tiles. Key Engineering materials, Trans Tech Publications, Vols. 264-268, (2004), 1519-1522.
European Standard EN 101: Ceramic tiles-Determination of the scratch hardness of surface according to Mohs. First edition 1982-09.
European Standard EN 623-4: Advanced technical ceramics-monolithic ceramics-general and textural properties-Part 4: Determination of surface roughness. 2004.
E. Sánchez, J. García-Ten, M.J. Ibáñez, M.J. Orts, V. Cantavella, J. Sánchez, C. Soler: Polishing Porcelain Tile Part 1: Wear Mechanism. Am. Ceram. Soc. Bull., Vol. 81, No 9, 50-54, 2002.