Entropy generation of Al2O3/water nanofluid in corrugated channels

The flow of nanofluids in a corrugated channel has been shown to have a significant impact on heat transfer performance, and has therefore become an important area of research. The ob- jective of this paper is to understand the thermal behavior of Al2O3/water nanofluid in a sinu-soidal and square channel and to identify ways to optimize heat transfer performance in such configurations. For this purpose, a numerical simulation was conducted using ANSYS-Fluent software 16.0 on entropy generation and thermo-hydraulic performance of a wavy channel with the two corrugation profiles (sinusoidal and square). The analyses were carried out under laminar forced convection flow conditions with constant heat flux boundary conditions on the walls. The influence of various parameters, such as particle concentration (0–5%), particle di-ameter (10nm , 40nm and 60nm), and Reynolds number (200 < Re < 800) on the heat transfer, thermal, and frictional entropy generation, and Bejan number was analyzed. Moreover, the distribution of streamlines and static temperature contours has been presented and discussed, and a correlation equation for the average Nusselt number based on the numerical results is presented. One of the most significant results obtained is that the inclusion of nanoparticles (5% volume fraction) in the base fluid yielded remarkable results, including up to 41.92% and 7.03% increase in average Nusselt number for sinusoidal and square channels, respectively. The sinusoidal channel exhibited the highest thermo-hydraulic performance at Re= 800 and φ= 5%, approximately THP= 1.6. In addition, the increase of nanoparticle concentration from 0% to 5% at Re= 800 and dnp= 10nm, diminishes the total entropy generation by 28.39 % and 22.12 % for sinusoidal and square channels, respectively, but when the nanoparticle diameter decreases from 60nm to 10nm at ϕ= 5% and Re= 800, the total entropy generation in the sinusoidal channel decreases by 34.85%, whereas in the square channel, it decreases by 20.05%. Therefore, rather than using a square channel, it is preferable and beneficial to use small values of nanoparticle diameter and large values for each of ϕ and Re in the sinusoidal wavy channel. Overall, the study of nanofluid flow in a wavy channel can provide valuable insights into the behavior of nanofluids and their potential applications in a variety of fields, including manufacturing, energy produc-tion, mining, agriculture, and environmental engineering.

Keywords:

Entropy Generation, Laminar Flow Nanofluid, Sinusoidal and Square Channel,

PDF

___

REFERENCES
[1] Hamza NFA, Aljabair S. Review of Heat transfer enhancement using hybrid nano fluid or twisted tape insert. J Mech Eng Res Dev 2021;44:345357. [CrossRef]
[2] Ahmed SH, Abdulhassan AK, Sattar A. Review of computational multi-phase approaches of nano-fluids filled systems. Therm Sci Eng Progress 2022;28:101175. [CrossRef]
[3] Taşkesen E, Tekir M, Pazarlıoğlu HK, Gurdal M, Gedik E, Arslan, K. The effect of MHD flow on hydrothermal characteristics of ferro-nano-fluid in circular pipe. Experimental Heat Transfer 2022;36:617-631. [CrossRef]
[4] Insiat IR, Hossain F, Shafwat AS, Sadrul Islam AKM. Numerical simulation on performance evaluation among metal and oxide based nanofluids for power savings application of a circular tube. J Therm Eng 2021;7:1150–1162. [CrossRef]
[5] Hamza NFA, Aljabair S. Evaluation of thermal performance factor by hybrid nanofluid and twisted tape inserts in heat exchanger. Heliyon 2022;8:e11950. [CrossRef]
[6] Ekiciler R. A CFD investigation of Al2O3/water flow in a duct having backward-facing step. J Therm Eng 2019;5:3141. [CrossRef]
[7] Aljabair S, Mohammed AA, Alesbe I. Natural convection heat transfer in corrugated annuli with H2O-Al2O3 nanofluid. Heliyon 2020;6:e05568. [CrossRef]
[8] Kaya H, Alkasem M, Arslan K. Effect of nanoparticle shape of Al2O3/Pure Water nanofluid on evacuated U-Tube solar collector efficiency. Renew Energy 2020;162:267284. [CrossRef]
[9] Ekiciler R, Çetinkaya MSA, Arslan K. Heat transfer enhancement in an equilateral triangular duct by using an Al 2 O 3/water nanofluid: Effect of nanoparticle shape and volume fraction. Heat Transf Res 2020;51:741757. [CrossRef]
[10] Kurtulmuş N, Sahin B. A review of hydrodynamics and heat transfer through corrugated channels.Int Commun Heat MassTransf 2019;108:10430. [CrossRef]
[11] Wang CC, Chen CK. Forced convection in a wavy-wall channel. Int J Heat Mass Transf 2002;45:2587–2595. [CrossRef]
[12] Aljabair S, Ekaid AL. Ibrahim SH, Alesbe I. Mixed convection in sinusoidal lid driven cavity with non-uniform temperature distribution on the wall utilizing nanofluid. Heliyon 2021;7:e06907. [CrossRef]
[13] Gürsoy E, Pazarlıoğlu HK, Dağdeviren A, Gürdal M, Gedik E, Arslan K, Kurt H. Energy analysis of magnetite nanofluid flowing in newly designed sudden expansion tube retrofitted with dimpled fin. Int J Heat Mass Transf 2022;199:123446. [CrossRef] [14] Habeeb AS, Aljabair S, Karamallah AA. Experimental and numerical assessment on hydrothermal behaviour of MgO-Fe3O4/H2O hybrid nano-fluid. Int J Thermofluids 2022;16:100231.
[15] Hamza NFA, Aljabair S. Numerical and experimental investigation of heat transfer enhancement by hybrid nanofluid and twisted tape. Eng Technol J 2023;41:6985. [CrossRef]
[16] Albojamal A, Hamzah H, Haghighi A, Vafai K. Analysis of nanofluid transport through a wavy channel. Numerical Heat Transfer, Part A: Applications 2017;72:869880. [CrossRef]
[17] Heidary H, Kermani MJ. Effect of nano-particles on forced convection in sinusoidal-wall channel. Int Commun Heat Mass Transf 2010;37:1520–1527. [CrossRef]
[18] Mahian O, Kianifar A, Kleinstreuer C, Al-Nimr MA, Pop I, Wongwises S, Sahin AZ. A review of entropy generation in nanofluid flow. Int J Heat Mass Transf 2013;65:514–532. [CrossRef]
[19] Taskesen E, Tekir M, Gedik E, Arslan K. Numerical investigation of laminar forced convection and entropy generation of Fe3O4 /water nanofluids in different cross sectioned channel geometries. J Therm Eng 2021;7:1752–1767. [CrossRef]
[20] Pazarlıoğlu HK, Gürsoy E, Gürdal M, Tekir M, Gedik E, Arslan K, Taşkesen E. The first and second law analyses of thermodynamics for cofe2o4/h2o flow in a sudden expansion tube inserted elliptical dimpled fins. Int J Mech Sci 2023;246:108144. [CrossRef]
[21] Pazarlıoğlu HK, Ekiciler R, Arslan K, Mohammed NAM. Exergetic, energetic, and entropy production evaluations of parabolic trough collector retrofitted with elliptical dimpled receiver tube filled with hybrid nanofluid. Appl Therm Eng 2023;223:120004. [CrossRef]
[22] Akbarzadeh M, Rashidi S, Esfahani JA. Influences of corrugation profiles on entropy generation heat transfer, pressure drop, and performance in a wavy channel. Appl Therm Eng 2017;116:278291. [CrossRef]
[23] Rashidi S, Akbarzadeh M, Masoodi R, Languri EM. Thermal-hydraulic and entropy generation analysis for turbulent flow inside a corrugated channel. Int J Heat Mass Transf 2017;109: 812823. [CrossRef]
[24] Esfahani, JA, Akbarzadeh, M, Rashidi, S, Rosen, MA, Ellahi R. Influences of wavy wall and nanoparticles on entropy generation over heat exchanger plat. Int J Heat Mass Transf 2017;109:1162–1171. [CrossRef]
[25] Hudhaifa H, Besir Sahin S. Analysis of SWCNT-water nanofluid flow in wavy channel under turbulent pulsating conditions: Investigation of homogeneous and discrete phase models. Int J Therm Sci 2023;184:108011. [CrossRef]
[26] Boudraa B, Bessaih R. Heat transfer and entropy generation of water/TiO2 nanofluid flow in a wavy channel using two-phase mixture approach. Thermophys Aeromechanics 2022;29:587604. [CrossRef]
[27] Ehsan E-B, Moghadam MC, Niazmand H, Daungthongsuk W, Wongwises S. Experimental and numerical investigation of nanofluids heat transfer characteristics for application in solar heat exchangers. Int J Heat Mass Transf 2016;92:1041–1052. [CrossRef]
[28] Omri M, Bouterra M, Ouri H, Kolsi L. Entropy generation of nanofluid flow in hexagonal microchannel. J Taibah Univ Sci 2022;16:7588. [CrossRef]
[29] Saha G, Paul MC. Numerical analysis of the heat transfer behavior of water-based Al2O3 and TiO2 nanofluids in a circular pipe under the turbulent flow condition. Int Commun Heat Mass Transfer 2016;56:96–108. [CrossRef]
[30] Pak BC, Cho YI. Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles. Exp Heat Transf Int J 1998;11:151–170. [CrossRef] [31] Xuan Y, Roetzel W. Conceptions for heat transfer correlation of nanofluids. Int J Heat Mass Transfer 2000;43:3701–3707. [CrossRef]
[32] Corcione, M. Empirical correlating equations for predicting the effective thermal conductivity and dynamic viscosity of nanofluids. Energy Convers Manag 2011;52:789–793. [CrossRef]
[33] Rudyak VY. Viscosity of nanofluids – why it is not described by the classical theories. Adv Nano 2013;2:266279. [CrossRef]
[34] Bejan A. General criterion for rating heat-exchanger performance. Int J Heat Mass Transf 1978;21:655658. [CrossRef]
[35] Bejan A. Study of entropy generation in fundamental convective heat transfer. J Heat Trans 1979;101:718–725. [CrossRef]
[36] Haseli Y. Entropy Analysis in Thermal Engineering Systems Book. Cambridge, Massachusetts: Imprint Academic Press; 2018. p. 202.
[37] Basak T, Kaluri RS ,Balakrishnan A. Effects of thermal boundary condition on entropy generation during natural convection. Numer Heat Transf Part A 2011;59:372402. [CrossRef]
[38] Patankar SV. Computation of Conduction and Duct Flow Heat Transfer. New York: Hemisphere Publishing Corporation;1988.
[39] ANSYS Inc. Fluent User Guide and Fluent Theory Guide, version 16.0. ANSYS Inc.
[40] Ahmed,M.A., Yusoff, M.Z., Ng, K.C., Shuaib,N.H. Numerical and experimental investigations on the heat transfer enhancement in corrugated channels using SiO2-water nanofluid.Case Studies in Thermal Engineering 2015;6:7792. [CrossRef]
[41] Sarviya RM, V Fuskele. Review on thermal conductivity of nanofluids. Mater Today Proc 2017;4:4022–4031. [CrossRef]
[42] Moghaddami M, Shahidi S, Siavashi M. Entropy generation analysis of nanofluid flow in turbulent and laminar regimes. J Comput Theor Nanosci 2012;9:15861595. [CrossRef]
[43] Bianco V, Manca O, Nardini S. Entropy generation analysis of turbulent convection flow of Al2O3–water nanofluid in a circular tube subjected to constant wall heat flux. Energy Convers Manag 2014;77:306314. [CrossRef]