Comparative analysis of carbon particle emissions from exhaust of an IC engine using HSD and blends of HSD and Honge/Jatropha biodiesel

Comparative analysis of carbon particle emissions from exhaust of an IC engine using HSD and blends of HSD and Honge/Jatropha biodiesel

In spite of the surge in solar and wind energy in the recent years, the IC engines, particularly the diesel engines may be expected to stay on for the next 30 years at least. In this context, it is imperative to find alternative fuel sources for petro diesel, at least in part. Inedible oil based biodiesels are one good option for India. There is a slight decrease in performance of a diesel engine when run with biodiesel blends. It is also feared by some that pollution from exhaust gas by using biodiesel blends may be higher. This paper summarizes the results of experiments carried out on biodiesel blends with diesel to determine the amounts and particle sizes of carbon particulate matter emissions in engine exhaust. Blends of two esterified oils, viz., Honge (Pongamia Pinnata) and Jatropha, with petro diesel were used to operate a single-cylinder, four-stroke diesel engine. Blend ratios used were 5%, 10%, 15%, and 20%. The carbon particles in exhaust were collected on an INDICA filter paper for 5 minutes. The carbon content was ascertained by the standard procedure, and the size of particles was found by microscopic examination. Further ANOVA of the data was car-ried out separately for the Honge and Jatropha blends. The results from the experiments are clear and interesting. Both Honge and Jatropha blends increase the amount of carbon particulates in engine exhaust when compared with diesel. Car-bon particulates increase with increase in load on the engine. Increase of blend ratio generally increases the carbon in exhaust in case of Jatropha blends. The behaviour with Honge blends is different. While blend H5 has highest carbon in exhaust at low loads, at high loads, H10 has the maximum carbon in exhaust. Blending with Honge or Jatropha biodiesel increases the carbon particle size in exhaust. While the size of carbon particles with diesel is < 20 µm, it is > 20 µm with all blends, increasing with load or blend ratio. In all cases, lower loads result in finer carbon particles in exhaust. The study helps in concluding that both Honge and Jatropha blends could be used in diesel en-gines, Honge being superior. Though the PM level in the exhaust will be higher with blending, the particle sizes will be much larger and hence causing less health hazard. Further, idling (no load), or low loads should be avoided since these result in smaller carbon particles.

___

  • REFERENCES
  • [1] Pousa GPAG, Santos ALF, Suarez PAZ. History and policy of biodiesel in Brazil. Energy Policy 2007;35:393398. [CrossRef]
  • [2] India Import-Export Trend, 2020-21, india-briefing.com/news/indias-import-eport-trends-in-2020-21-trade-diversification-fta-ftp-plans-23305.html/.
  • [3] Wei-Dong H, Chen R-H, Wu T-L, Lin T-H. Engine performance and pollutant emission of an SI engine using ethanol–gasoline blended fuels. Atmos Environ 2002;36:403410. [CrossRef]
  • [4] Shi HC, Jian JS, Wang X. Study on combustion characteristics and PM emission of diesel engines using ester–ethanol–diesel blended fuels. Proceed Combust Inst 2007;31:29812899. [CrossRef]
  • [5] Damani N, Chyuan Ong H, Wen Tong C, Indra Mahlia TM, Silitonga AS. A review on the engine performance and exhaust emission characteristics of diesel engines fueled with biodiesel blends. Environ Sci Pollut Res 2018;25:15307–15325. [CrossRef]
  • [6] ElKasaby M, Nemit-allah M. Experimental investigations of ignition delay period and peformance of a diesel engine operated with jatropha oil biodiesel. Alexandria Eng J 2013;52:141149. [CrossRef]
  • [7] Banapurmath NR, Tewari PG, Gaitonde VN. Experimental investigation on perfoamance and emission characteristics of honge oil biodiesel (HOME) operated compression ignition engine. Renew Energy 20212;48:193201. [CrossRef]
  • [8] Rashid U, Anwar F, Knothe G, Evaluation of biodiesel obtained from cottonseed oil. Fuel Process Tech 2009;90:11511163. [CrossRef]
  • [9] Kumar Agarwal A, Gupta T, Shukla PC, Dhar A. Particulate emissions from biodiesel fuelled CI engines. Energy Convers Manag 2015;94:311–330. [CrossRef]
  • [10] Pawar SK, Hole JA. Performance evaluation and emission testing of simarouba oil seeds biodiesel blends in CI engine. Int Res J Eng Tech 2019;6-8:1115.
  • [11] Das M, Sarkar M, Datta A. An experimental study on the combustion, performnce and emission characteristics of a diesel engine fuelled with diesel-castor oil biodiesel blends. Renew Energy 2018;1199:174184. [CrossRef]
  • [12] Bosch R. Automotive Handbook. 5th ed. Bosch GmBH, Germany, 2000.
  • [13] Kundu KM. Combustion of coal-oil mixture, Proc. IX ISME Conference on Mechanical Engineering, November 10-11, University of Roorkee, Roorkee, India, 1994.
  • [14] Kolakoti, A, Koten H. Effect of supercharging in neat biodiesel fuelled naturally aspirated diesel engine combustion, vibration and emission analysis Energy 2022;260:125054. [CrossRef]
  • [15] Altuntaş C, Tunalıoğlu N. Estimation performance of soil moisture with GPS-IR method. Sigma J Eng Nat Sci 2020;38:22172230.
Journal of Thermal Engineering-Cover
  • Başlangıç: 2015
  • Yayıncı: YILDIZ TEKNİK ÜNİVERSİTESİ
Sayıdaki Diğer Makaleler

Thermal insulation performance curves for exterior walls in heating and cooling seasons

Mohammad Ahmad BATIHA, Saleh RAWADİEH, Marwan BATIHA, Leema AL-MAKHADMEH, Muhammet KAYFECI, Freabdullah MARACHLI

Theoretical exploration of low GWP refrigerant mixtures as replacement to HFC-134A in a vapour compression refrigeration system

Mohammed HASHEER SK, Srinivas KOLLA, Dasari KONDALA RAO, Yellapragada NAGA VENKATA SAI RAM

Performance parameters, design considerations, social adoption, and computational techniques for solar box cooker development: current status and future possibilities

Satish Kumar DEWANGAN

Measurements of heat transfer coefficients from supercritical fluid flowing in vertical mini channels with constant wall temperature

Ameer Abed JADDOA

A CFD investigation of the design variables affecting the performance of finned-tube heat exchangers

Hussaini Syed MUJTABA, Tariq FEROZE, Ahmad HANAN, Haider Ali SHAMS

A review on battery thermal management strategies in lithium-ion and post-lithium batteries for electric vehicles

Sahin GUNGOR, Sinan GOCMEN, Erdal CETKIN

Entropy generation of Al2O3/water nanofluid in corrugated channels

Leila SAOUDI, Nordine ZERAIBI

Performance enhancement of absorption refrigeration systems: An overview

Abhishek VERMA, Subhash Chandra KAUSHIK, Sudhir Kumar TYAGI1

An allusive realization on the performance analysis of glass to glass, glass to tedlar and aluminum base flexible photovoltaic (PV) module

Vivek CHOPRA, Rajeev Kumar MISHRA, Vijay Kumar DWIVEDI, Baibaswata MOHAPATRA

Parameter optimization of coriolis mass flow meter in laminar flow regime using Doe-Taguchi method

Vikram KOLHE, Suyash PAWAR, Vishal CHAUDHARI, Ravindra EDLABADKAR, Sandipkumar SONAWANE