Korasikha Naga RAMESH, Thopudurthi Karthikeya SHARMA

Thermal analysis of PCM-based hybrid micro-channel heat sinks: A numerical study

Heat sinks play a vital part in the heat dissipation in electronic devices and energy systems. Heat generation in the present-time electronic equipment is very high because of the high power density and the miniaturization of the components. An efficient and high-capacity thermal management system is needed for the efficient performance of the latest electron-ic equipment. Micro-channel heat sinks (MCHS) are an effective solution for the cooling of electronic devices in view of large heat dissipation and compactness. The performance im-provement in the MCHS is the prime focus of most of the researchers. In the present work, the improvement of heat transfer in MCHS with the introduction of phase change material (PCM) was investigated numerically with the help of ANSYS-FLUENT. The finding of the computational model applied for the present numerical work was compared with existing literature and noticed a good agreement with both experimental and simulation studies. The performance of three different PCM-based hybrid MCHS models was studied and compared with the model of MCHS without PCM using the parameters, thermal resistance, temperature uniformity, liquid fraction, and Nusselt number. A good augmentation in the performance of PCM-based MCHS with a maximum 7.3% decrement in thermal resistance and 15.26% in-crease in temperature uniformity was observed. 3-dimensional variation of the liquid fraction with Reynolds number and heat flux is also presented.

Keywords:

Thermal Management Electronic Cooling, Hybrid Micro-Channel Heat Sink,

PDF

___

REFERENCES
[1] Lan Y, Feng Z, Huang K, Zhang J, Hu Z. Effects of truncated and offset pin-fins on hydrothermal performance and entropy generation in a rectangular microchannel heat sink with variable fluid properties. Int Commun Heat Mass Transf 2021;124:105258. [CrossRef]
[2] Ho CJ, Liu YC, Ghalambaz M, Yan WM. Forced convection heat transfer of Nano-Encapsulated Phase Change Material (NEPCM) suspension in a mini-channel heatsink. Int J Heat Mass Transf 2020;155:119858. [CrossRef]
[3] Ma Y, Shahsavar A, Talebizadehsardari P. Two-phase mixture simulation of the effect of fin arrangement on first and second law performance of a bifurcation microchannels heatsink operated with biologically prepared water-Ag nanofluid. Int Commun Heat Mass Transf 2020;114:104554. [CrossRef]
[4] Tuckerman DB, Pease RFW. High-performance heat sinking for VLSI. IEEE Electron Device Lett 1981;2:126129. [CrossRef]
[5] Mokrane M, Lounis M, Announ M, Ouali M, Djebiret MA, Bourouis M. Performance Analysis Of A Micro Heat Exchanger In Electronic Cooling Applications. J Therm Eng 2021;7:774–790. [CrossRef] [6] Gaikwad VP, Mohite SS. Performance analysis of microchannel heat sink with flow disrupting pins. J Therm Eng 2022;8:402–425. [CrossRef]
[7] Rana S, Dura HB, Bhattrai S, Shrestha R. Impact of baffle on forced convection heat transfer of CuO/water nanofluid in a micro-scale backward facing step channel. J Therm Eng 2022;8:310–322. [CrossRef]
[8] Kumar S, Sarkar M, Singh PK, Lee PS. Study of thermal and hydraulic performance of air cooled minichannel heatsink with novel geometries. Int Commun Heat Mass Transf 2019;103:31–42. [CrossRef]
[9] Aryan Saini R, Vohra M, Singh A, Rabbani T, Choudhary M. Comparative thermal performance evaluation of a heat sink based on geometrical and material amendments: A numerical study. Mater Today Proc 2022;50:816–822. [CrossRef]
[10] Bayer Ö, Baghaei Oskouei S, Aradag S. Investigation of double-layered wavy microchannel heatsinks utilizing porous ribs with artificial neural networks. Int Commun Heat Mass Transf 2022;134:105984. [CrossRef]
[11] Kose HA, Yildizeli A, Cadirci S. Parametric study and optimization of microchannel heat sinks with various shapes. Appl Therm Eng 2022;211:118368. [CrossRef]
[12] Gorzin M, Ranjbar AA, Hosseini MJ. Experimental and numerical investigation on thermal and hydraulic performance of novel serpentine minichannel heat sink for liquid CPU cooling. Energy Rep 2022;8:3375–3385. [CrossRef]
[13] Qasem NAA, Zubair SM. Compact and microchannel heat exchangers: A comprehensive review of air-side friction factor and heat transfer correlations. Energy Convers Manag 2018;173:555–601. [CrossRef]
[14] Sahar AM, Wissink J, Mahmoud MM, Karayiannis TG, Ashrul Ishak MS. Effect of hydraulic diameter and aspect ratio on single phase flow and heat transfer in a rectangular microchannel. Appl Therm Eng 2017;115:793–814. [CrossRef]
[15] Ji Y, Yuan K, Chung JN. Numerical simulation of wall roughness on gaseous flow and heat transfer in a microchannel. Int J Heat Mass Transf 2006;49:1329–1339. [CrossRef]
[16] Soleimanikutanaei S, Ghasemisahebi E, Lin CX. Numerical study of heat transfer enhancement using transverse microchannels in a heat sink. Int J Therm Sci 2018;125:89–100. [CrossRef] [17] Wang G, Qian N, Ding G. Heat transfer enhancement in microchannel heat sink with bidirectional rib. Int J Heat Mass Transf 2019;136:597–609. [CrossRef]
[18] Zhang Y, Wang S, Ding P. Effects of channel shape on the cooling performance of hybrid micro-channel and slot-jet module. Int J Heat Mass Transf 2017;113:295–309. [CrossRef]
[19] Kuppusamy NR, Mohammed HA, Lim CW. Numerical investigation of trapezoidal grooved microchannel heat sink using nanofluids. Thermochim Acta 2013;573:39–56.
[20] Kuppusamy NR, Mohammed HA, Lim CW. Thermal and hydraulic characteristics of nanofluid in a triangular grooved microchannel heat sink (TGMCHS). Appl Math Comput 2014;246:168–183. [CrossRef]
[21] Ghale ZY, Haghshenasfard M, Esfahany MN. Investigation of nanofluids heat transfer in a ribbed microchannel heat sink using single-phase and multiphase CFD models. Int Commun Heat Mass Transf 2015;68:122–129. [CrossRef]
[22] Manay E, Akyürek EF, Sahin B. Entropy generation of nanofluid flow in a microchannel heat sink. Results Phys 2018;9:615–624. [CrossRef]
[23] Rostami J, Abbassi A. Conjugate heat transfer in a wavy microchannel using nanofluid by two-phase Eulerian-Lagrangian method. Adv Powder Technol 2016;27:918. [CrossRef]
[24] Saeed M, Berrouk AS, AlShehhi MS, AlWahedi YF. Numerical investigation of the thermohydraulic characteristics of microchannel heat sinks using supercritical CO2 as a coolant. J Supercrit Fluids 2021;176:105306. [CrossRef]
[25] Mozafari M, Lee A, Mohammadpour J. Thermal management of single and multiple PCMs based heat sinks for electronics cooling. Therm Sci Eng Prog 2021;23:100919. [CrossRef]
[26] Mahdi JM, Mohammed HI, Talebizadehsardari P. A new approach for employing multiple PCMs in the passive thermal management of photovoltaic modules. Sol Energy 2021;222:160–174. [CrossRef]
[27] Alehosseini E, Jafari SM. Nanoencapsulation of phase change materials (PCMs) and their applications in various fields for energy storage and management. Adv Colloid Interface Sci 2020;283:102226. [CrossRef]
[28] Deng X, Wang S, Wang J, Zhang T. Analytical modeling of microchannel heat sinks using microencapsulated phase change material slurry for chip Cooling. Procedia Eng 2017;205:27042711. [CrossRef]
[29] Ho CJ, Chang PC, Yan WM, Amani P. Efficacy of divergent minichannels on cooling performance of heat sinks with water-based MEPCM suspensions. Int J Therm Sci 2018;130:333–346. [CrossRef]
[30] Yan WM, Ho CJ, Tseng YT, Qin C, Rashidi S. Numerical study on convective heat transfer of nanofluid in a minichannel heat sink with micro-encapsulated PCM-cooled ceiling. Int J Heat Mass Transf 2020;153:119589. [CrossRef]
[31] Rajabifar B. Enhancement of the performance of a double layered microchannel heatsink using PCM slurry and nanofluid coolants. Int J Heat Mass Transf 2015;88:627–635. [CrossRef]
[32] Su W, Darkwa J, Kokogiannakis G. Review of solid–liquid phase change materials and their encapsulation technologies. Renew Sustain Energy Rev 2015;48:373–391. [CrossRef]
[33] Yadav A, Soni S. Simulation of melting process of a phase change material (PCM) using ANSYS (Fluent). Int Res J Eng Technol 2017:2395–2356.
[34] Al-Rashed AAAA, Shahsavar A, Rasooli O, Moghimi MA, Karimipour A, Tran MD. Numerical assessment into the hydrothermal and entropy generation characteristics of biological water-silver nano-fluid in a wavy walled microchannel heat sink. Int Commun Heat Mass Transf 2019;104:118126. [CrossRef]
[35] Wong KC, Muezzin FNA. Heat transfer of a parallel flow two-layered microchannel heat sink. Int Commun Heat Mass Transf 2013;49:136140. [CrossRef]