Seebeck coefficient of Ca2.8Pr0.2Co4O9 synthesized by sol-gel method with thermal and structural characterization

In this paper, Ca2.8Pr0.2Co4O9 powders were synthesized by sol-gel method and thermal and structural characterization of the powders were systematically examined for high temperature thermoelectric generator applications. Differential Thermal Analysis-Thermogravimetry (DTA-TG) was used to specify appropriate thermal regime of the powders for calcination process. Chemical structure and reaction type of intermediate temperature products were defined by Fourier Transform Infrared (FTIR) Spectroscopy. Structural properties of the powders were implemented by X-ray Diffraction (XRD) and X-ray Photoelectron Spectroscopy (XPS) was used to specify chemical composition and empirical formula of the elements existed within the powders. It can be seen from the phase spectrum that 2θ peaks of Ca2.8Pr0.2Co4O9 correspond to the literature and coincide with typical Ca3Co4O9 peaks. Seebeck coefficients of the samples are much higher than Ca3Co4O9 while they are closer to literature value of Ca2.8Pr0.2Co4O9. The highest Seebeck coefficient of Ca2.8Pr0.2Co4O9 is found to be 179 µV/K at 400 °C which is a little higher than the literature value. These results show that Pr is an effective dopant to increase the Seebeck coefficient values.

___

J. Garcia-Canadas and G. Min, "Multifunctional probes for high-throughput measurement of Seebeck coefficient and electrical conductivity at room temperature," Rev Sci Instrum, vol. 85, p. 043906, Apr 2014.

M. S. Dresselhaus, G. Chen, Z. F. Ren, G. Dresselhaus, A. Henry, and J.-P. Fleurial, "New Composite Thermoelectric Materials for Energy Harvesting Applications," JOM, vol. 61, pp. 86-90, 2009.

S. Bhattacharya, S. Rayaprol, A. Singh, A. Dogra, C. Thinaharan, D. K. Aswal, et al., "Low temperature thermopower and electrical transport in misfit Ca3Co4O9 with elongated c-axis," Journal of Physics D: Applied Physics, vol. 41, p. 085414, 2008.

R. Funahashi, M. Mikami, T. Mihara, S. Urata, and N. Ando, "A portable thermoelectric-power-generating module composed of oxide devices," Journal of Applied Physics, vol. 99, p. 066117, 2006.

Y. Song, Q. Sun, L. Zhao, F. Wang, and Z. Jiang, "Synthesis and thermoelectric power factor of (Ca0.95Bi0.05)3Co4O9/Ag composites," Materials Chemistry and Physics, vol. 113, pp. 645-649, 2009.

L. Han, N. V. Nong, L. T. Hung, T. Holgate, N. Pryds, M. Ohtaki, et al., "The influence of α- and γ-Al2O3 phases on the thermoelectric properties of Al-doped ZnO," Journal of Alloys and Compounds, vol. 555, pp. 291- 296, 2013.

H. Alam and S. Ramakrishna, "A review on the enhancement of figure of merit from bulk to nano-thermoelectric materials," Nano Energy, vol. 2, pp. 190-212, 2013.

Y. Wang, Y. Sui, J. Cheng, X. Wang, and W. Su, "Comparison of the high temperature thermoelectric properties for Ag-doped and Ag-added Ca3Co4O9," Journal of Alloys and Compounds, vol. 477, pp. 817-821, 2009.

N. Van Nong, N. Pryds, S. Linderoth, and M. Ohtaki, "Enhancement of the thermoelectric performance of p-type layered oxide Ca(3)Co(4)O((9)+delta) through heavy doping and metallic nanoinclusions," Adv Mater, vol. 23, pp. 2484-90, Jun 3 2011.

C. Chen, T. Zhang, R. Donelson, D. Chu, R. Tian, T. T. Tan, et al., "Thermopower and chemical stability of Na0.77CoO2/Ca3Co4O9 composites," Acta Materialia, vol. 63, pp. 99-106, 2014.

H. Su, Y. Jiang, X. Lan, X. Liu, H. Zhong, and D. Yu, "Ca3 − xBixCo4O9 and Ca1 − ySmyMnO3 thermoelectric materials and their power-generation devices," physica status solidi (a), vol. 208, pp. 147-155, 2011.

K. Park, H. K. Hwang, J. W. Seo, and W. S. Seo, "Enhanced high-temperature thermoelectric properties of Ce- and Dydoped ZnO for power generation," Energy, vol. 54, pp. 139-145, 2013.

S. W. Nan, J.; Deng, Y.; Nan, C.W., "Synthesis and thermoelectric properties of (NaxCa(1-x))3Co4O9 ceramics," Journal of the European Ceramic Society vol. 23, pp. 859- 863, 2003.

A. Goktas, I. H. Mutlu, Y. Yamada, and E. Celik, "Influence of pH on the structural optical and magnetic properties of Zn1−xMnxO thin films grown by sol–gel method," Journal of Alloys and Compounds, vol. 553, pp. 259-266, 2013.

M. H. Bocanegra-Bernal, "Hot Isostatic Pressing (HIP) technology and its applications to metals and ceramics," Journal of Materials Science, vol. 39, pp. 6399-6420, 2004.

K. A. Borup, J. de Boor, H. Wang, F. Drymiotis, F. Gascoin, X. Shi, et al., "Measuring thermoelectric transport properties of materials," Energy Environ. Sci., vol. 8, pp. 423-435, 2015.

E. Celik, U. Aybarc, M. F. Ebeoglugil, I. Birlik, and O. Culha, "ITO films on glass substrate by sol–gel technique: synthesis, characterization and optical properties," Journal of Sol-Gel Science and Technology, vol. 50, pp. 337-347, 2009.

H. Q. Liu, X. B. Zhao, T. J. Zhu, Y. Song, and F. P. Wang, "Thermoelectric properties of Gd, Y co-doped Ca3Co4O9+δ," Current Applied Physics, vol. 9, pp. 409-413, 2009.

M. Rezaei, M. Khajenoori, and B. Nematollahi, "Preparation of nanocrystalline MgO by surfactant assisted precipitation method," Materials Research Bulletin, vol. 46, pp. 1632-1637, 2011.

F. P. Zhang, X. Zhang, Q. M. Lu, J. X. Zhang, Y. Q. Liu, and G. Z. Zhang, "Effects of Pr doping on thermoelectric transport properties of Ca3−xPrxCo4O9," Solid State Sciences, vol. 13, pp. 1443-1447, 2011.
Sakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi-Cover
  • ISSN: 1301-4048
  • Yayın Aralığı: Yılda 6 Sayı
  • Başlangıç: 1997
  • Yayıncı: Sakarya Üniversitesi Fen Bilimleri Enstitüsü
Sayıdaki Diğer Makaleler

Tek silindirli bir dizel motorda atık biyodizel kullanımının motor performansı ve emisyonlarına etkisi

MUSTAFA AYDIN, MEHMET AFŞAR, M. Bahattin ÇELİK

Bir transformatör işletmesinde montaj ünitesinin ergonomik analizi

DEMET GÖNEN OCAKTAN, ALİ ORAL, M A Beyazıt OCAKTAN, Aslan Deniz Karaoglan, Abdullah CİCİBAŞ

Ön gerilmeli monotron tipi halatın deneysel ve teorik doğal frekans analizi

Cihan DEMİR, Erkan ALA

Gemi formundaki yapıların güvertelerinde sıklıkla karşılaşılan çatlaklar ve dizaynı düzeltme ve geliştirme yolları

Özgür ÖZGÜÇ

Betonarme kirişlerin deneysel ve teorik burulma momenti değerlerinin karşılaştırılması

Abdülkadir Cüneyt AYDIN, Barış BAYRAK

Kirlenmiş topraklardaki p,p'-DDE'nin kabak bitki özsuyu ile ilişkili biriktirme mekanizması

MEHMET İŞLEYEN, BEYTULLAH EREN, AHMET AYGÜN

Yol yüzey işaretlerinde kullanılan malzemeler ve geri yansıma özellikleri üzerine bir literatür taraması

METİN MUTLU AYDIN

Yaşam döngüsü analizinin ambalaj atıklarının yönetiminde kullanılması

ALİYE SUNA ERSES YAY

Numerical investigation of operating fluid, rotating disk speed effects and number of cavities on drag reduction of micro-textured surfaces for hydrodynamic lubrication

Ahmet Çağrı DEVELİ, Ali Bahadır OLCAY

Hidrodinamik yağlamada kullanılan mikro-doku yüzeyler üzerinde akışkanın, diskin açısal hızının ve boşluk sayısının direnç azalmasına etkilerinin sayısal incelenmesi

Ali Bahadır OLCAY, Ahmet Çağrı DEVELİ