___

• Kanai, H., Abe, M. ve Kido, K., 1987,
• “Estimation of the Surface Roughness on the
• Race or Ball of Ball Bearing by Vibration
• Analysis”, Trans. ASME J. Vibration, Stress ve
• Reliability in Design, Vol. 109, pp. 60-68.
• McFadden, P.D. ve Smith, J.D., 1984, “Vibration
• Monitoring of Rolling Element Bearings by the
• Hihg-Frequency Resonance Technique-A
• Review”, Int. J. of Tribology, Vol. 17, pp. 3-10.
• Tandon, N. ve Choudhury, A., 1999, “A Review
• of Vibration and Acoustic Measurement Methods
• for the Detection of Defects in Rolling Element
• Bearigns”, Tribology Int., Vol.32, pp. 469-480.
• McFadden, P.D. ve Smith, J.D., 1984, “Model for the
• Vibration Produced by a Single Point Defect in a
• Rolling Element Bearing”, JSV, Vol. 96(1), pp. 69-
• -
• McFadden, P.D. ve Smith, J.D., 1985, “The Vibration
• Produced by Multiple Point Defects in a Rolling
• Element Bearing”, JSV, Vol. 98(2), pp. 263-273.
• Tandon, N. ve Choudhury, A., 1997, “An
• Analytical Model for the Prediction of the
• Vibration Response of Rolling Element Bearing
• due to Localized Defect”,JSV, Vol.205(3), pp.
• -292.
• Kiral, Z. ve Karagülle, H., 2003, “Simulation and
• analysis of Vibration Signals Generated by
• Rolling element Bearing with Defects”, Tribology
• Int., Vol. 36, pp. 667-678.
• Sopanen, J. ve Mikkola, A., 2003, “Dynamic
• Model of a Deep-groove Ball Bearing Including
• Localized and Distributed Defects. Part 1:
• Theory”, Proc. IMechE Part K: J. of Multi-body
• Dynamics, Vol 217, pp. 201-211.
• Sopanen, J. ve Mikkola, A., 2003, “Dynamic
• Model of a Deep-groove Ball Bearing Including
• Localized and Distributed Defects. Part 1:
• Theory”, Proc. IMechE Part K: J. of Multi-body
• Dynamics, Vol 217, pp. 213-223.
• Karaçay, T. “Açısal Temaslı Rulmanlarla
• Yataklanmış Şaftların Dinamiği Ve Rulman
• Hatalarının Deneysel Analizi”, Doktora Tezi,
• Gazi Üniversitesi, Fen Bilimleri Enstitüsü,
• Ankara, 2006.
• Ho, D. ve Randall, R.B., 2000, “Optimisation of
• Bearing Diagnostic Techniques Using Simulated
• and Actual Bearing Fault Signals”, MSSP, Vol.
• (5), pp. 763-788.
• Brie, D., 2000, “Modelling of the Spalled Rolling
• Element Bearing Vibration Signal: An Overview
• and Some New Results”, MSSP, Vol. 14(3), pp.
• -369.