ÜÇÜNCÜ DERECEDEN YENİ BİR QUADRATURE OSİLATÖR TASARIMI

Bu çalışmada, son zamanlarda oldukça fazla dikkat çeken bir aktif eleman olan Terslenmiş Akım Geri Beslemeli İşlemsel Yükselteç (ICFOA) kullanılarak üçüncü dereceden quadrature osilatör devresi sunulmuştur. Topoloji iki adet ICFOA, üç adet kapasitör ve üç adet direnç olmak üzere gerilim modlu ikinci dereceden alçak geçiren filtre ve gerilim modlu integratör yapısının kaskat bağlanıp kapalı çevrim oluşturması ile elde edilmiştir. Sunulan devrenin çalışabilirliği PSPICE benzetim programı ile denenmiş ve teorik sonuçlar ile örtüştüğü görülmüştür. Teorik kesim frekansı 3,979MHz ve benzetim sonucu ölçülen kesim frekansı ise 3,933MHz’dir. Benzetimde 0,35 μm MOSIS parametre seti ve ICFOA CMOS yapısı kullanılmıştır. Önerilen devrenin güç tüketimi 4,83mW’dır.

A New Third Order Quadrature Oscillator Design

In this work, a third-order quadrature oscillator circuit is presented by using an inverting current feedback operational amplifier (ICFOA), an active element that has attracted considerable attention in recent years. The topology consists of two ICFOA, three capacitors and three resistors by connecting a voltage mode second-order low-pass filter and a voltage-mode integrator with a cascaded closed loop. The workability of the circuit is verified by PSPICE simulation program and it is seen that the simulation results verify the theory and the proposed circuit has good performance. The theoretical cut-off frequency is 3,979MHz and the cut-off frequency measured after the simulation is 3,933MHz. In the simulation, 0,35 μm MOSIS parameter set and ICFOA CMOS structure are used. The proposed circuit power consumption is 4,83mW.

___

  • 1. Chaturvedi B. , Maheshwari S. , 2013. Third-Order Quadrature Oscillator Circuit with Current and Voltage Outputs. Hindawi Publishing Corporation ISRN Electronics .
  • 2. Chen HP.,2014. Current-mode dual-output ICCII-based tunable universal biquadratic filter with low-input and high-output impedances. Int J Circuit Theory Appl ;42(4):376–93.
  • 3. Chen HP., 2014. Voltage-mode multifunction biquadratic filter with one input and six outputs using two ICCIIs, Scientific World Journal, vol. 2014, pp. .
  • 4. Chen HP., Huang W., Hsieh MY., Wu KH., 2014.Universal current mode biquadratic filter with two inputs and four outputs using ICCIIs. International Conference on Information Science, Electronics and Electrical Engineering
  • 5. Chiu W. , Liu S.I, Tsao H.W. , Chen J.J. 1996. CMOS differential difference current conveyors and their applications. IEE Proceedings – Circuits, Devices and Systems, 143, ss. 91–96.
  • 6. Ettaghzouti, T., Hassen, N., Garradhi, K., & Besbes, K. 2018. Generation of Oscillator Circuits Using Two ICCII-Generation Current Conveyors. In 2018 15th International Multi-Conference on Systems, Signals & Devices (SSD) (pp. 441-446). IEEE.
  • 7. Gökçen A. , Göçmen MS., Çam U. 2012 .Second order analog filter desing using a single ICCII. Signal Processing and Communications Applications Conference (SIU).
  • 8. Horng J.W., Hou C.L., Chang C.M., Chung W.-Y., Tang H.-W. and Wen Y-H. 2005.Quadrature oscillators using CCIIs. Int. J. Electron, vol. 92, pp. 21–31.
  • 9. Horng J.-W., Hou C.-L., Chang C.-M., Pan S.-W., Shie J.-Y., and Wen Y.-H., 2007.Third-order quadrature oscillator with grounded capacitors using CCIIs. WSEAS Transactions on Electronics, vol. 4, no. 1, pp. 20–22.
  • 10. Horng J.-W., Lee H., and Wu J.-Y., 2010. Electronically tunable third-order quadrature oscillator using CDTAs. Radioengineering, vol. 19, no. 2, pp. 326–330
  • 11. Ibrahim M. A., Kuntman H. 2002.High linearity CMOS differential current conveyor(DDCC). International Conference on Microelectronics, ss. 6–9.
  • 12. Ibrahim M. A., Kuntman H. , Ozcan S. , Suvak O. , Cicekoglu O. 2004 . New first-order inverting-type second-generation current conveyor-based all-pass sections including canonical forms. Electrical Engineering, 86, ss. 299–301.
  • 13. Maheshwari S. and Khan I. A., 2005 .Current controlled third order quadrature oscillator. IEE Proceedings: Circuits, Devices & Systems, vol. 152, no. 6, pp. 605–607.
  • 14. Manetakis K., Toumazou C. 1996. Current-feedback opamp suitable for CMOS VLSI technology. Electronic Letters, 32, pp. 1090–1092.
  • 15. Minaei S., Yuce E., Cicekoglu O. 2006. ICCII-based voltage-mode filter with single input and six outputs employing grounded capacitors. Circuits, Systems, and Signal Processing, 25, ss. 559–566 .
  • 16. Pandey R., Pandey N., and Paul S. K., 2012. MOS-C third order quadrature oscillator using OTRA. Proceedings of the 3rd International Conference on Computer and Communication Technology, pp. 77–80.
  • 17. Safari, L., Yuce, E., & Minaei, S. 2017. A new ICCII based resistor-less current-mode first-order universal filter with electronic tuning capability. Microelectronics journal, 67, 101-110.
  • 18. Soliman A. M. 2008. The inverting second generation current conveyors as universal building blocks. International Journal of Electronics and Communications (AEU), 62, ss. 114–121.
  • 19. Soliman, A. M. 2010. On the transformation of a floating resistor oscillator to grounded passive element oscillators. Majlesi Journal of Electrical Engineering, 4(3), 1-6.
  • 20. Sözen H., Gökçen A., Kilinç S, Çam U. 2011. Inverting Current Feedback Operational Amplifier and Its Applications to MOS-C Circuit Realization. Electrical and Electronics Engineering (ELECO),p. II-69-II-73
Uludağ Üniversitesi Mühendislik Fakültesi Dergisi-Cover
  • ISSN: 2148-4147
  • Yayın Aralığı: Yılda 3 Sayı
  • Başlangıç: 2002
  • Yayıncı: BURSA ULUDAĞ ÜNİVERSİTESİ > MÜHENDİSLİK FAKÜLTESİ
Sayıdaki Diğer Makaleler

MÜHENDİSLİK EĞİTİMİNDE GEOMETRİK TOLERANSLARIN ÖĞRETİMİNE YÖNELİK ARTIRILMIŞ GERÇEKLİK UYGULAMASI GELİŞTİRİLMESİ

Muhammed KOFOĞLU, Abdil KUŞ, Derya EMRELİ, Rıdvan ARSLAN, Ertu UNVER, Mike KAGIOGLOU

YAPILARDA YAYGIN KULLANILAN ISI YALITIM MALZEMELERİNİN PERFORMANS ÖZELLİKLERİNİN DUVAR KESİTLERİ ÜZERİNDE DEĞERLENDİRİLMESİ

Nazife ÖZER, Seden ACUN ÖZGÜNLER

DOĞAL VE SENTETİK LİF ESASLI KOMPAKT İPLİKLERDEN ÜRETİLEN GÖMLEKLİK KUMAŞLARIN BAZI MEKANİK VE HAVA GEÇİRGENLİĞİ ÖZELLİKLERİNİN İNCELENMESİ

Erhan Kenan ÇEVEN, Gizem KARAKAN GÜNAYDIN

DYNAMIC SIMULATION OF A PV/WIND HYBRID POWER GENERATION SYSTEM: CASE STUDY OF BURSA PROVINCE

Ayşe Fidan ALTUN, Muhsin KILIÇ

Kuru Tip Transformatörlerin Dış Ortamlarda Kullanılabilmesi İçin Deneysel Ve Simülasyon Ile Termal Analizine Yeni Yaklaşım

Murat TÖREN, Mehmet Mesut ÇELEBİ

ÇELİK TEL DONATILI BETONLARIN MEKANİK ÖZELLİKLERİNİN GÖRÜNTÜ ANALİZLERİ İLE TAHMİNİ

Eyüp TAŞKAN, Yunus GÜNDÜZ, Yuşa ŞAHİN

Çörekotu Yağı İçeren Poliüretan Nanolifli Yüzeylerin Morfolojik Özellikleri Üzerine Bazı Proses Parametrelerinin Etkilerinin Araştırılması

Cansu ARAS, Şebnem DÜZYER GEBİZLİ, Elif TÜMAY ÖZER, Emine Esra KARACA

EKLEMELİ İMALAT (3B BASKI): TEKNOLOJİLER VE UYGULAMALAR

Hasan Kemal SÜRMEN

Farklı Tipte FR4 Kaplamaları için 28 GHz Mikroşerit Yama Anteni Tasarımı ve Analizi

Bahadır HİÇDURMAZ, Ömer Faruk GÜMÜŞ

ÜÇÜNCÜ DERECEDEN YENİ BİR QUADRATURE OSİLATÖR TASARIMI

İhsan KARACAN, Ahmet GÖKÇEN