Calculation of surface leakage currents on high voltage insulators by ant colony algorithm-supported FEM

The weakness of the outer insulation at high voltages is the reduction of the surface resistance as a result of the environmental pollution yielding formation of flashover due to the surface leakage currents. In this study, it was shown how to calculate the surface leakage currents resulting in flashover in polluted insulators and therefore power cuts by means of the ant colony algorithm (ACA). For this purpose, first, field distribution on the sample insulator surface in question was defined by the Laplace equation ($\nabla^{2}$V = 0). With the help of the finite element method (FEM), the Laplace equation was obtained as an equation with a complex coefficient as a complex dielectric coefficient was used in the problem, which was converted to a set of linear equations. The solution of this problem was performed by FEM. For this purpose, a 2D finite element mesh was constructed for the area in question and the voltages at the nodes of this mesh were calculated. The current value was then calculated by transferring these voltages to the open model (AR model) obtained from the 3D model of the insulator. The ACA was used in the current calculations. After certain values of the leakage current, dry bands formed on the surface where partial arcs occurred as a result of the increase in voltage drops. Accordingly, rapid variations occurred in the current values and the electric field strengths. These variations, appearing until the formation of an arc throughout the whole leakage current distance, were calculated gradually by the ACA. The results obtained were presented graphically.

Anahtar Kelimeler:

High voltage insulator, pollution flashover, dynamic arc model, ant colony algorithm

Calculation of surface leakage currents on high voltage insulators by ant colony algorithm-supported FEM

Keywords:

High voltage insulator, pollution flashover, dynamic arc model, ant colony algorithm,

PDF

___

Sundararajan R, Gorur RS. Dynamic arc modeling of pollution flashover of insulators under DC voltage. IEEE T Electr Insul 1993; 28: 209–218.
Haznadar Z, Sokolija K, Sadovic S. Dynamic model of pollution flashover. In: Sixth International Symposium on High Voltage Engineering; 1989; New Orleans, LA, USA.
Rizk F. Mathematical models for pollution flashover. Electra 1981; 78: 71–103.
Rumeli A, Hızal M, Demir Y. Analytical estimation of flashover performances of polluted insulators. In: 1st International Symposium on Pollution Performance of Insulators and Surge Diverters; 1981; Madras, India.
Claverie P, Porcheron Y. How to choose insulators for polluted areas. IEEE T Power Ap Syst 1973; 92: 1121–1131. Williams DL, Haddad A, Rowlands AR, Young HM, Waters RT. Formation and characterization of dry bands in clean fog on polluted insulators. IEEE T Dielect El In 1999; 6: 724–731.
Jolly DC, Poole CD. Flashover of contaminated insulators with cylindrical symmetry under DC conditions. IEEE T Electr Insul 1979; 14: 77–84.
Lambeth PJ. Effect of pollution on high-voltage outdoor insulators. P I Electr Eng 1974; 118: 1107–1130.
Astorga OAM, Do Prado AJ. The flashover phenomenon: an analysis with influence of the thickness of the layer pollution of the high voltage polluted insulators. In: Conference Records of the 1994 IEEE International Symposium
on Electrical Insulation; 1994; Pittsburgh, PA, USA. pp. 546–549.
Kontargyri VT, Gialketsi AA, Tsekouras GJ, Gonos IF, Stathopulos IA. Design of an artificial neural network for the estimation of the flashover voltage on insulators. Electr Pow Syst Res 2007; 77: 1532–1540.
Tsarabaris PT, Karagiannopoulos CG, Theodorou NJ. A model for high voltage polluted insulators suffering arcs and partial discharges. Simul Model Pract Th 2005;13: 157–167.
Vinay J. Finite element analysis of electric field around an ice-covered semi-conducting glazed insulator using a form of Kelvin transformation. J Electrostat 2011; 69: 15–22.
Kontargyri VT, Plati LN, Gonos IF, Stathopulos IA. Measurement and simulation of the voltage distribution and the electric field on a glass insulator string. Measurement 2008; 41: 471–480.
Dhahbi-Megriche N, Beroual A, Krahenbuhl L. A new proposal model for flashover of polluted insulators. J Phys D Appl Phys 1997; 30: 889–894.
Gellert BC, Rasmussen JK. Finite element modeling of dry zone formation on polluted outdoor HV insulators. In: Sixth International Symposium on High Voltage Engineering; 1989; New Orleans, LA, USA.
Anjana S, Lakshminarasimha CS. Computation of flashover voltages of polluted insulators using dynamic arc model. In: Sixth International Symposium on High Voltage Engineering; 1989; New Orleans, LA, USA.
Aydogmus Z. A neural network-based estimation of electric fields along high voltage insulators. Expert Syst Appl 2009; 36: 8705–8710.
Gen¸co˘glu MT, Cebeci M. Investigation of pollution flashover on high voltage insulators using artificial neural network. Expert Syst Appl 2009; 36: 7338–7345.
Asimakopoulou GE, Kontargyri VT, Tsekouras GJ, Elias CN, Asimakopoulou FE, Stathopulos IA. A fuzzy logic optimization methodology for the estimation of the critical flashover voltage on insulators. Electr Pow Syst Res 2011; 81: 580–588.
Holtzhausen JP. A critical evaluation of AC pollution flashover models for HV insulators having hydrophilic surfaces. PhD, University of Stellenbosch, Stellenbosch, South Africa, 1997.
Verma MP. Highest Leakage Current Impulse as Criterion for the Performance of Polluted Insulators. Paris, France: CIGRE.
Holtzhausen JP, Du Toit LP. Insulator pollution: interrelationship of highest leakage current, specific creepage distance and salinity. P SAIEE 1987; 78: 1.
Holtzhausen JP, Vosloo WL. The pollution flashover of AC energised post type insulators: the role of shortening of the arc. IEEE T Dielect El In 2001; 8: 191–194.
Schwardt HW, Holtzhausen JP, Vosloo WL. A comparison between measured leakage current and surface con- ductivity during salt fog tests. In: 7th AFRICON Conference in Africa; 2004; Johannesburg, South Africa. pp. 597–600.
Rumeli A. Kirli izole y¨uzeylerde de¸sarjların yayılımı ve atlama. Elektrik M¨uhendisli˘gi 1973; 199: 419–427 (in Turkish).
Zhicheng G, Yinke M, Liming W, Ruihai L, Hua W, Yi M. Leakage current and discharge phenomenon of outdoor insulators. International Journal on Electrical Engineering and Informatics 2009; 1: 1.
Jayasundara HIS, Sudarshani WPS, Fernando MARM. Leakage current patterns on high voltage insulators: analysis on frequency and time-frequency domain. In: Third International Conference on Industrial and Information Systems; 2008; Kharagpur, India. pp. 1–6.
Ya˘gdıran ZO. Y¨uksek gerilim izolat¨orlerinin performansını belirlemede bir deneysel y¨ontem. MSc, Fırat University, Elazı˘g, Turkey, 1997 (in Turkish).
Rumeli A. Homojen kirle kaplı y¨uksek gerilim izolat¨orlerinin dayanım gerilimlerinin hesaplanması. Professorship thesis, Middle East Technical University, Ankara, Turkey, 1979 (in Turkish).
C¸ anak¸cı M. Sonlu elemanlar y¨ontemi yardımıyla y¨uksek gerilim izolat¨orlerinde y¨uzey alan da˘gılımının hesabı MSc, Fırat University, Elazı˘g, Turkey, 1993 (in Turkish).
¨Ozt¨urk D, Cebeci M. Kirlenmi¸s y¨uksek gerilim izolat¨orlerinde y¨uzey ka¸cak akımlarının karınca koloni algoritması ile hesaplanması. In: FEEB 2011 Elektrik Elektronik Bilgisayar Sempozyumu; 2011; Elazı˘g, Turkey. pp. 65–70.
Cebeci M, K¨ur¨um H, Akpınar S. Lagrange multipliers for the intermediate metallic regions in the computation of the potential distribution of insulator chains by FEM. Electr Mach Pow Syst 1998; 26: 495–505.