AN INVESTIGATION OF GRINDING CHARACTERISTICS OF NA-FELDSPAR BY MEANS OF THE KINETIC MODEL PARAMETERS

In this study, the specific rates of breakage (Si) and the primary breakage distribution (Bi,j) values of Na-feldspar were determined for four mono-sized feed fractions; -0.106+0.090 mm, -0.090+0.075 mm, -0.075+0.063 mm, and -0.063+0.045 mm. Batch dry grinding tests were carried out for 0.25 and 0.50 minutes of grinding time by using labratory grinding mill having cylpebs with 10 mm diameter. And then the kinetic model parameters (Si, aT, α, γ and ϕJ) were calculated and presented in a comparative manner for different grinding times.

Keywords:

Breakage parameters cylpebs milling, kinetic model, na-feldspar.,

PDF

___

[1] Tanaka K., Minai K., Wakino K., Uei I., (1986) Submicron Grinding of BaTiO3 by Ball Milling, Journal of the Society of Materials Science Japan 35, 54–58.
[2] Tanaka T., (1995) Optimum Design for Fine and Ultrafine Grinding Mechanisms Using Grinding Media, Kona Powder and Particle Journal 13, 19–29.
[3] Yokoyama T., Taniyama Y., Jimbo G., Zhao Q., (1991) The Grinding Equilibrium Size of in-Water Grinding of Silica Sand by a Planetary Ball Mill, Journal of the Society of Powder Technology Japan 28, 751–758.
[4] Zhao Q., Yamada S., Jimbo G., (1988) The Mechanism and Limit of Fineness of a Planetary Mill Grinding, Journal of the Society of Powder Technology Japan 25, 297–302.
[5] Schonert K., (1982) About the Particle Breakage and the Possibilities and Limits for Improving Size-Reduction Processes, In: Proceedings of International Symposium on Powder Technology, The Society of Powder Technology, Kyoto, 331–345.
[6] Schonert K., (1990) Physical and Technical Aspects of Very and Micro Tine Grinding, In: Proceedings of Second World Congress Particle Technology, Society of Powder Technology, Kyoto, 257–271.
[7] Austin LG., (1992) Some Topics for Research on Fine Grinding, In: Lecture in Harrogate Meeting IFPRI.
[8] Austin LG., Klimpel RR., Luckie PT., (1984) Process Engineering of Size Reduction: Ball Milling SME-AIME, New York.
[9] Austin LG., (1972) A Review Introduction to the Description of Grinding as a Rate Process, Powder Technology 5, 1–7.
[10] Austin LG., Bagga P., Çelik M., (1981) Breakage Properties of Some Materials in a Laboratory Ball Mill, Powder Technology 28, 235–241.
[11] Austin LG., Bhatia VK., (1971/1972) Experimental Methods for Grinding Studies in Laboratory Mills, Powder Technology 5, 261–266.
[12] Deniz V., Onur T., (2002) Investigation of the Breakage Kinetic of Pumice Samples as Dependent on Powder Filling in a Ball Mill, International Journal of Mineral Processing 67, 71–78.

Sigma Mühendislik ve Fen Bilimleri Dergisi-Cover

ISSN: 1304-7191
Yayın Aralığı: Yılda 4 Sayı
Yayıncı: Yıldız Teknik Üniversitesi

Arşiv