EXPERIMENTAL INVESTIGATION AND PERFORMANCE OPTIMIZATION OF A CROSS FLOW HEAT EXCHANGER BY ENTROPY GENERATION MINIMIZATION APPROACH
The exergy loss and performance optimization of
a cross flow heat exchanger (CFHE) with air and hot water as working fluid have
been experimentally investigated. Experiments are performed on various mass
flow rates of hot water and air over a ranges of 0.015 kg.s-1– 0.04
kg.s-1 and 0.117 kg.s-1 - 0.763 kg.s-1
respectively. To validate the results of the present study, they are compared
with available data in literature through which a reasonably a good agreement
is obtained between them. This study demonstrates the successful application of
Taguchi approach for optimal design of the (CFHE). The effects of design
parameters and two different operating conditions such as the fin pitch, the
inside tube diameter and the mass flow rate of water and air on exergy loss are
investigated. In the Taguchi experimental design method, exergy loss is considered
as performance parameter and it is revealed that parameter combinations such as
h=0.0163 kg.s-1,
a=0.1175 kg.s-1, di=0.0199 m and Fp=0.00259
m resulted optimum performance. Contribution ratios of each parameter on exergy
loss are assessed. Mass flow rate of air is determined to be the most effective
parameter on exergy loss with a contribution ratio of 51.26 % followed by mass
flow rate of hot water, fin pitch, and diameter contribution ratios of 35.91 %, 7.02 % , 5.79 % respectively.
Keywords:
Experimental Investigation, Cross Flow Heat Exchanger, Performance Optimization, Exergy Analysis Taguchi Method,
___
- [1] Ko, T.H. (2006). Thermodynamic analysis of optimal curvature ratio for fully developed laminar forced convection in a helical coiled tube with uniform heat flux. International Journal of Thermal Sciences, 45(7), 729-737.
- [2] Imran, M., Pambudi, N.A., Farooq, M. (2017).Thermal and hydraulic optimization of plate heat exchanger using multi objective genetic algorithm. Case Studies in Thermal Engineering, 10, 570-578.
- [3] Kotcioglu, I., Cansiz, A., Nasiri Khalaji, M. (2013). Experimental investigation for optimization of design parameters in a rectangular duct with plate-fins heat exchanger by Taguchi method. Applied Thermal Engineering, 50, 604-613.
- [4] Ipek, O., Kılıc, B., Gurel, B. (2017). Experimental investigation of exergy loss analysis in newly designed compact heat exchangers. Energy, 124, 330-335.
- [5] Sahin, B. (2005). Optimum design parameters of a heat exchanger. Applied Energy, 82(1), 90-106.
- [6] Yakut, K. (2006). Experimental investigation of thermal resistance of a heat sink with hexagonal fins. Applied Thermal Engineering, 26(17), 2262-2271.
- [7] Kotcioglu, I., Caliskan, S., Baskaya S. (2011). Experimental study on the heat transfer and pressure drop of a cross-flow heat exchanger with different pin–fin arrays. Heat and mass transfer, 47(9), 1133.
- [8] Bahiraei, M., Heshmatian, S. (2017). Application of a novel biological nanofluid in a liquid block heat sink for cooling of an electronic processor: Thermal performance and irreversibility considerations. Energy Conversion and Management, 149, 155–167.
- [9] Bahiraei, M., Gharagozloo, K., Alighardashi, M, Mazaheri, N. (2017). CFD simulation of irreversibilities for laminar flow of a power-law nanofluid within a minichannel with chaotic perturbations: An innovative energy-efficient approach. Energy Conversion and Management, 144, 374-387.
- [10] Heshmatian, S., Bahiraei, M. (2017). Numerical investigation of entropy generation to predict irreversibilities in nanofluid flow within a microchannel: Effects of Brownian diffusion, shear rate and viscosity gradient. Chemical Engineering Science, 172, 52-65.
- [11] Bahiraei, M., Mohammadi, S. (2016). Prediction of entropy generation for nanofluid flow through a triangular minichannel using neural network. Advanced Powder Technology, 27, 673-683.
- [12] Bahiraei, M., Alighardashi, M. (2016). Investigating non-Newtonian nanofluid flow in a narrow annulus based on second law of thermodynamics. Journal of Molecular Liquids, 219, 117-127.
- [13] Gunes, S., Manay, E., Senyigit, E., Ozceyhan, V. (2011). A Taguchi approach for optimization of design parameters in a tube with coiled wire inserts. Applied Thermal Engineering, 31, 2568-2577.
- [14] Gnielinski, V. (1976). New equation for heat and mass transfer in turbulent pipe and channel flow, International Chemical Engineering, 16, 359-368.
- [15]Rout S.K., Choudhury B. K, Sahoo R. K., Sarangi S. K. (2014). Multi-objective parametric optimization of Inertance type pulse tube refrigerator using response surface methodology and non-dominated sorting genetic algorithm.Cryogenics 62, 71-83.
- Başlangıç: 2015
- Yayıncı: YILDIZ TEKNİK ÜNİVERSİTESİ
Sayıdaki Diğer Makaleler