Şaban PUSAT, Mustafa Tahir AKKOYUNLU, Hasan Hüseyin ERDEM

DETERMINATION OF INLET AIR FLOW RATE IN GAS TURNINES

Performance of gas turbines, which have been used commonly in electricity production and cogeneration systems, affect cost of electricity considerably. However, for determination and recovery of performance losses and for doing planned maintenance, lots of measurements and analyses are required. As in all turbo machineries, one of these measurements is flow rate of process fluid. Aim of this study is to give a method to calculate compressor inlet air mass flow that is difficult to measure and has low reliability for gas turbines. The calculation method mainly based on combustion equation and measured data taken from flue gas emission device. Basic inputs of the method are fuel content, fuel mass flow, relative humidity, temperature and pressure of ambient air and oxygen content and pressure of flue gas. By using this method for gas turbines, compressor inlet air mass flow can be calculated practically. By this means, it is possible to determine and follow the performance of compressor and gas turbine correctly by operators.

Keywords:

Gas turbine compressor inlet air flow, oxygen rate, fuel content,

PDF

___

[1] Gay R.R., Palmer C.A. ve Erbes M.R., “Power plant performance monitoring”, 2004.
[2] Devki Energy Consultancy Pvt. Ltd. (2006) BEE Code “Cogeneration”. Available from: www.energymanagertraining.com [accessed January 6, 2014].
[3] Emission Inventory Improvement Program (2001) Preferred and Alternative Methods for Estimating Air Emissions from Boilers. Available from: www.epa.gov [accessed January 6, 2014].
[4] KEMA, “Validated Methods for Flue Gas Flow Rate Calculation with Reference to EN 12952-15”, 2012.
[5] Energy efficiency guide for industry in Asia (2006) Thermal Energy Equipment: Boilers & Thermic Fluid Heaters. Available from: www.energyefficiencyasia.org [accessed January 6, 2014].
[6] Logan E. Ve Roy R., “Handbook of Turbomachinery”, 2. Baskı, 2003.
[7] Silveira J.L. ve Tuna C.E. “Thermoeconomic analysis method for optimization of combined heat and power system. Part I”, Progress in Energy and Combustion Science, 2003.
[8] Çengel A.Y. ve Boles M.A., “Termodinamik (Mühendislik Yaklaşımıyla)”, 5. Baskı, 2011.
[9] Karadavut D., “Emisyon Ölçüm Kuralları ve Ölçüm Programı”.

Sigma Mühendislik ve Fen Bilimleri Dergisi-Cover

ISSN: 1304-7191
Yayın Aralığı: Yılda 4 Sayı
Yayıncı: Yıldız Teknik Üniversitesi

Arşiv