A RESEARCH ON THE EFFECT OF THE REINFORCEMENT GEOMETRY ON THE SOIL BEARING CAPACITY UNDER THE STRIP FOOTING LOADS

Increasing the bearing capacity in the soils could be rational and economical solution for the shallow foundations in the geotechnical design. When the soil is loose and incapable of carrying loads from foundation, soil improvement appears to be essential. For this reason, the usage of geogrids for reinforcement of foundation soils is one of the principal ways in soil improvement, which is used horizontally as the reinforcement to increase the soil strength. In this research, a geotextile layer with wraparound ends is accomplished on the granular soils because of increasing the load capacity. For this purpose, a modified form of the geogrid alongside the installation method was explored. In addition, PLAXIS (2D) finite element analysis software was employed to model and analyze the new design of the reinforcement. The acquired results demonstrated that the new geometrical form could improve the soil to a greater extent and reduced the settlements, compared to the horizontal reinforcement system.

Keywords:

Geotextile, wraparound ends, strip footing settlement, reinforced soil, PLAXIS.,

PDF

___

[1] Keskin M.S., (2009) Güçlendirilmiş Kumlu Şevlere Oturan Yüzeysel Temellerin Deneysel ve Teorik Analizi, PhD Thesis, Graduate School of Natural and Applied Sciences, Çukurova University, Adana, Turkey.
[2] Akbulut S, Pamukcu S, (2010) Evaluation of dynamic properties of geosynthetic reinforced clay samples for environmental impact practices. Environmental Earth Sciences 61, 1449- 1456.
[3] Abiera H.O., (1991) Mechanically stabilized earth using Tensar, bamboo and steel grid Reinforcements with weathered Bangkok clay as backfill, Msc Thesis, Asian Institute of technology, Bangkok, Thailand.
[4] Unnikrishnan K., Rajagopal N.R., Krishnaswamy., (2002) Behavior of reinforced clay under monotonic and cyclic loading. Geotextiles and Geomembrances 20, 117-133.
[5] Shin E.C., Das V.M., Pur V.K., Cook E.E., Yen S.C., (1993) Bearing capacity of a strip Foundation geogrid reinforced clay, Geotechnical Testing Journal 16, 534-541.
[6] Ghiassian H., (2004) Influence of Encapsulated Geogrod-Sand System on Bearing Capacity and Settlement Characteristics of Reinforced clay, International Journal of Civil Engineering 2, 45-53.
[7] Huang C.C., Tatsuoka F., (1990) Bearing Capacity of Reinforced Horizontal Sandy Ground, Geotextile and Geomembranes 9, 51-82.
[8] Mandal J.N., Sah H.S., (1992) Bearing Capacity Tests on Geogrid Reinforced Clay, Geotextile and Geomembranes 11, 327-333.
[9] Dixit R.K., Mandal J.N., (1993) Bearing Capacity of Geosynthetic Reinforced Soil Using Variational Method, Geotextiles and Geomembranes 12, 543-566.
[10] Khing K.H., Das B.M., Puri V.K., Cook E.E., Yen S.C. (1993) Bearing Capacity of a Strip Foundation on Geogrid-Reinforced Sand, Geotextile and Geomembranes 12, 351- 361.
[11] Yetimoğlu T., Wu J.T.H., Saglamer A., (1994) Bearing Capacity of Rectangular Footings on Geogrid-Reinforced Sand, Journal of Geotechnical Engineering 120, 2083- 2099.
[12] Adams M.T., Collin J.G., (1997) Large Model Spread Footing Load Tests on Geosyntetic Reinforced Soil Foundation, Journal of Geotech and Geoenvir Engineering 123, 66-72.
[13] Kumar A., Saran S., (2003) Closely Spaced Footings on Geogrid Reinforced Sand, Journal of Geotechnical and Geoenvironmental Engineering 129, 660-664.
[14] Michalowski R.L., (2004) Limit Loads on Reinforced Foundation Soils, Journal of Geotechnical and Geoenvironmental Engineering 130, 381-390.
[15] Koerner R.M., (2005) Designing with geosynthetics, 5th ed. Prentice Hall, New Jersey.
[16] Kumar A., Walia B.S., (2006) Bearing Capacity of Square Footings on Reinforced Layered Soil. J. Geotechnical and Geological Engineering 24, 1001-1008.
[17] Shukla S.K., Yin J.H., (2006) Fundamentals of geosynthetic engineering. Taylor and Francis, London.
[18] Shukla S.K., (2012) Handbook of geosynthetic engineering. ICE, London.
[19] Kazi M., Shukla S. K., Habibi D., (2015) An Improved Method to Increase the Load- Bearing Capacity of Strip Footing Resting on Geotextile- Reinforced Sand Bed, Indian Geotechnical Journal 45, 98-109.
[20] Azzam W.R., Nasr A.M., (2014) Bearing capacity of shell strip footing on reinforced sand, Journal of Advanced Research 6, 727-737.
[21] Al-Saied A.E., Saleh N.M., Elmashad M.E., (2014) Behavior of circular footing resting on laterally confined granular reinforced soil, HBRC Journal 11, 240-245.
[22] Naderi E., Hataf N., (2014) Model testing and numerical investigation of interference effect of closely spaced ring and circular footings on reinforced sand, Geotextiles and Geomembranes 42, 191-200.
[23] Chakraborty D., Kumar J., (2014) Bearing Capacity of Circular Footings on Reinforced Soils, International Journal of Geomechanics 15, 1-9.
[24] Lai J., Chung S. Y., Yang B. H., Wu S., (2014) Numerical Study on Enhancing the Bearing Capacity of Shallow Foundation Using Geosynthetics, Innovative and Sustainable Use of Geomaterials and Geosystems, Geo-Hubei 2014 International Conference on Sustainable Civil Infrastructure, July 20-22, 2014, Yichang, Hubei, China, 64-70.
[25] Marandi S. M., Bagheripour M. H., Rahgozar R., Ghirian A. R., (2008) Numerical Investigation Into The Behavior of Circular Pad Shallow Foundations Supported By Geogrid Reinforced Sand , American Journal of Applied Sciences 5, 355-368.
[26] Krabbenhøft S., Damkilde L., Krabbenhøft K., (2016) Effect of slope height and horizontal forces on the bearing capacity of strip footings near slopes in cohesionless soil, Insights and Innovations in Structural Engineering, Mechanics and Computation: Proceedings of the Sixth International Conference on Structural Engineering, Mechanics and Computation, Cape Town, South Africa, 739-740.
[27] Yang S., Leshchinsky B., Zhang F., GaoY., (2016) Required strength of geosynthetic in reinforced soil structures supporting spread footings in three dimensions, Computers and Geotechnics 78, 72-87.
[28] Keawsawasvong S., Ukritchon B., (2017) Stability of unsupported conical excavations in non-homogeneous clays. Computers and Geotechnics 81, 125-136.
[29] Yu Y., Damians I. P., Bathurst R. J., (2015) Influence of choice of FLAC and PLAXIS interface models on reinforced soil-structure interactions, Computers and Geotechnics 65, 164-174.
[30] Melnikov R., Zazulya J., Stepanov M., Ashikhmin O., Maltseva T., (2016) OCR and POP parameters in Plaxis-based numerical analysis of loaded over consolidated soils, Procedia Engineering 165, 845-852.

Sigma Mühendislik ve Fen Bilimleri Dergisi-Cover

ISSN: 1304-7191
Yayın Aralığı: Yılda 4 Sayı
Yayıncı: Yıldız Teknik Üniversitesi

Arşiv