FARKLI KAYNAKLARDAN ÜRETİLMİŞ HİDROKSİAPATİTİN KEMİK ÇİMETOSU DAYANIMINA ETKİSİ
Bu çalışmada, iki farklı kalsiyum kaynağı kullanılarak üretilen hidroksiapatit katkısı eklenerek yüksek mukavemetli akrilik kemik yapıştırıcısı üretilmiştir. Üretilen örnekler, XRD ve FT-IR kullanılarak karakterize edilmiştir. Termal davranışlar ve yüzey morfolojileri DTA/TG ve SEM teknikleri kullanılarak belirlenmiştir. Ca(OH)2 ve deniz kabuğundan üretilen hidroksiapatit ilavesi, ortaya çıkan yapıştırıcıların basınç dayanımını (74 MPa'dan 106 MPa ve 103 MPa'ya) arttırmıştır. Bu yeni kemik yapıştırıcıları, ticari olarak temin edilebilen örneklerle karşılaştırılabilecek mekanik dayanımlara sahiptir ve hidroksiapatitin kemik yapısında mevcut doğal bir mineral olduğu için daha biyolojik olarak uyumlu olduğuna inanılmaktadır.
THE EFFECT OF HYDROXYAPATITE ADDITIVE PRODUCED FROM DIFFERENT RAW MATERIALS TO STRENGTH OF BONE CEMENT
In this study, production of acrylic bone cement which has high strength by adding hydroxyapatite additive that was produced using two different calcium sources was aimed. Characterizations were performed using XRD, and FT-IR. Thermal behaviors and surface morphologies were determined using DTA/TG and SEM techniques. The addition of hydroxyapatite produced from Ca(OH)2 and seashell increased the compressive strength (from 74 MPa to 106 MPa and 103 MPa) of the resultant cements respectively. These new bone cements have mechanical strengths comparable with commercially available cements and are believed to be more biocompatible since hydroxyapatite is a natural mineral present in the bone structure.
___
- [1] ZHANG, J., DAI, C.S., WEI, J., WEN, J.W., “Study on the bonding strength between calcium phosphate/chitosan composite coatings and a Mg alloy substrate”, Applied Surface Science, 261, 276-286, 2012.
- [2] KHALED, Z., Development of A New Generation of Bone Cements using Nanotechnology, Graduate Program in Engineering Science, School of Graduate and Postdoctoral Studies The University of Western Ontario, London, UK, 2009.
- [3] SERBETCI, K., KORKUSUZ, F., HASIRCI, N., “Mechanical and Thermal Properties of Hydroxyapatite-Impregnated Bone Cement”, Turkish Journal of Medical Sciences, 30, 543-549, 2000.
- [4] NIEN, Y.H., HUANG, C.L., “The mechanical study of acrylic bone cement reinforced with carbon nanotube”, Materials Science and Engineering, 169, 134-137, 2010.
- [5] MARANGOZ, S., “Bone Cement”, Totbid Jurnal, 10, 103-108, 2011.
- [6] RIVERA, E.M., ARAIZA, M., BROSTOW, W., CASTANO, V.M., ESTRADA, J.R.D., HERNANDEZ, R., RODRIGUEZ, J.R., “Synthesis of hydroxyapatite from eggshells”, Material Letters, 41, 128-134, 1999.
- [7] LEE, S.J., OH, S.H., “Fabrication of calcium phosphate bioceramics by using eggshell and phosphoric acid”, Material Letters, 57, 4570-4574, 2003.
- [8] BALÁZSI, C., WÉBER, F., KÖVÉR, HORVÁTH, Z. E., NÉMETH, A. “Preparation of calcium –phosphate bioceramics from natural resources”, Journal of the European Ceramic Society, 27, 1601-1606, 2007.
- [9] KENNETH, S.V., ZHANG, X., MASSIE, J.B., WANG, M., KIM, C., “Conversion of bulk seashells to biocompatible hydroxyapatite for bone implants”, Acta Biomaterialia, 3, 910-918, 2007.
- [10] RIPAMONTI, U., CROOKS, J., KHOALI, L., RODEN, L. “The induction of bone formation by coral-derived calcium carbonate/hydroxyapatite constructs”, Biomaterials, 30, 1428-1439, 2009.
- [11] JINAWATH, S., POLCHAI, D., YOSHIMURA, M., “Low-temperature, hydrothermal transformation of aragonite to hydroxyapatite”, Materials Science and Engineering: C, 22, 35-39, 2002.
- [12] CHAI, C.S., GROSS, K.A., NISSAN, B.B., “Critical ageing of hydroxyapatite sol–gel solutions”, Biomaterials, 19, 2291-2296, (1998).
- [13] YANG, X., WANG, Z., “Synthesis of biphasic ceramics of hydroxyapatite and b-tricalcium phosphate with controlled phase content and porosity”, Journal of Materials Chemistry, , 8, 2233-2237, 1998.
- [14] GERGELY, G., WEBER, F., LUKACS, I., ILLÉS, L., TÓTH, A.L., HORVÁTH, Z.E., MIHÁLY, J., BALÁZSI, C., “Nano-hydroxyapatite preparation from biogenic raw materials”, Central European Journal of Chemistry, 8,375-381, 2010.
- [15] SERBETCI, K., ORHUN, S., KORKUSUZ, F., HASIRCI, N., “In Vivo Biocompatibility Of Hydroxyapatite Containing Bone Cement”, Journal of Arthroplasty & Arthroscopic Surgery, 13, 259-263, 2002.
- [16] ZEBARJAD, S.M., SAJJADI, S.A., SDRABADI, T.E., YAGHMAEI, A., NADERI, B., “A Study on Mechanical Properties of PMMA/Hydroxyapatite Nanocomposite”, Scientific Research, 3, 795-801, 2011.
- [17] VERMA, D., “Design of polymer-biopolymer-hydroxyapatite biomaterials for bone tissue engineering: through molecular control of interfaces”, Ph.D. Thesis, North Dakota State University, North Dakota, USA, 2008.