___

• [1] Ş. Temiz, S. Akpinar, M.D. Aydın, E. Sancaktar, Increasing single-lap joint strength by adherend curvature-induced residual stresses, J. Adhesion Sci. Technol. 27, (2013), pp. 244-251. [2] Murat Yavuz SOLMAZ and Aydın TURGUT, An Experimental and Numerical Study on The Effects of Taper Angles and Overlap Length on The Failure and Stress Distribution of Adhesively-Bonded Single-Lap Joints, Mathematical and Computational Applications, 16 (2011), pp. 159-170. [3] A. M. G. Pinto, R. D. S. G. Campilho, I. R. Mendes, S. M. Aires, A. P. M. Babtista, Effect of hole drilling at the overlap on the strength of single-lap joints, Int. J. Adhes. Adhes. 31, (2011) 380-387. [4] Da Silva, L. F. M., Pirondi, A., and O¨ chsner, A., Hybrid Adhesive Joints, (Springer, Heidelberg, 2011). [5] Adin H., Temiz Ş., Experimental and numerical strength analysis of double lap joints subjected to tensile loads, Materials Testing, 56, (2014) pp. 160-168 [6] Sayman O, Elasto-plastic stress analysis in an adhesively bonded single lap joint, Composites Part B, 43 (2012), pp. 204-209. [7] M. Y. Solmaz, T. Topkaya, Progressive Failure Analysis in Adhesively, Riveted and Hybrid Bonded Double-Lap Joints, Journal of Adhesion, 89 (2013), pp. 822-836. [8] Ş. Temiz, Application of bi-adhesive in double strap joints subjected to bending moment, Journal of Adhesion Science and Technology, 20, (2006), pp. 1547-1560. [9] P. N. B. Reis, F. J. V. Antunes, J. A. M. Ferreira, Influence of superposition length on mechanical resistance of single-lap adhesive joints, Composite Structures, 67, (2005) 125-133. [10] A. Rudawska, Selected aspects of the effect of mechanical treatment on surface roughness and adhesive joint strength of steel sheets, Int. J. Adhes. Adhes. 50, (2014) pp. 235-243. [11] Zou GP, Shahin K, Taheri F. An analytical solution for the analysis of symmetric composite adhesively bonded joints, Composite Structures, 65, (2004) pp. 499-510.