Hasan Köten". Zafer Gül1
MULTIDIMENSIONAL MODELING OF COMPRESSED BIO GAS (CBG) ENGINE FOR ULTRA LOW EMISSION
The purpose of this study is to find out in-cylinder flow characteristics of a four-cylinder, 2,3 liter diesel engine before the fuel injection and also properly simulate the atomization process in order to improve the combustion efficiency and emission parameters. A complete intake stroke with Compressed Bio Gas (CBG) port injection, compression stroke, pilot fuel injection at the end of the compression and exhaust stroke simulated in 3D. Both naturally aspirated and turbo-charged modes of operations were studied. In this study, cold flow structure, fuel atomization for different spray models and dual fuel combustion are investigated. A comprehensive model for atomization of liquid sprays under high injection pressures has been employed. Finally, a calculation on an engine configuration with compression, spray injection and CBG-diesel combustion in a direct injection dual fuel diesel engine is presented. In 3D CFD study, selected proper cases modeled using full geometry of diesel engine. Fine grids were tested with 1,700,000 hexahedral cells. In this paper, fine grid results are evaluated. CBG fuel induced during intake process in dual fuel diesel combustion engine and then mixed with air before the premixed gas enters the cylinder. It is ignited by the injection of pilot diesel fuel near the Top Dead Center (TDC). This lean combustion and diluted gas mixture cause low in-cylinder temperature and resulting in a NOx emission. The results are in agreement qualitatively with the previous studies in the literature.
___
- SH. Yoon, SH. Park, C.S. Lee, Experimental investigation on the fuel properties of biodiesel and its blends at various temperatures, Energy and Fuels 22 (2008) 652—656.
- R.L. McCormic, C.]. Tennant, RR. Hayes, S. Black, Sharp, Regulated Emissions from Biodiesel Tested in Heavy Duty Engines Meeting 2004 Emission Standards, SAE 2005-01- 2200, 2005.
- M.Y. Kim, S.I-l. Yoon, C.S. Lee, Impact ofsplit injection strategy on the exhaust emissions and soot particulates Horn a compression ignition engine fueled with neat biodiesel, Energy and Fuels 22 (2008) 1260—1265.
- M.Y. Kim, SH. Yoon, J.W. Hwang, C.S. Lee, Characteristics of particulate emissions of compression ignition engine fueled with biodiesel derived from soybean, Journal of Engineering for Gas Turbine and Power 130 (5) (2008) 052805-1—052805—7.
- SH. Park, SH. Yoon, C.S. Lee, Effect of the temperature variation on properties of biodiesel and biodiesel—ethanol blends fuels, Oil & Gas Science and Technology 63 (6) (2008) 737—745.
- SH. Yoon, H.K. Suh, C.S. Lee, Effect of spray and EGR rate on the combustion and emission characteristics of biodiesel Şle] in a compression ignition engine, Energy and Fuels 23 (2009) 1486—1493.
- C. Rahmouni, M. Tazerout. 0. Le Corre, A method to determine biogas composition for combustion control, SAE 2002-01-1708, 2002.
- C. Tricase, M. Lombardi, State ofthe art and prospects of Italian biogas production from animal sewage: technical-economic considerations, Renewable Energy 34 (2009) 477—485.
- BB. Sahoo, N. Sahoo, UK. Saha, “Effect of engine parameters and type of gaseous Şle] on the performance of dual-fuel gas diesel engines-A critical review”, Renewable and Sustainable Energy Reviews 13 (2009) l ISI—1184.
- N.N. MustaŞ, RR. Raine, A study of the emissions of a dual fuel engine operating with alternative gaseous fuels, SAE 2008-01-1394, 2008.
- S. Maji, Amit Pal, BB. Arora, Use of CNG and diesel in CI engines in dual fuel mode. SAE 2008-28-0072, 2008.
- S. Jie, Q. Jun, Y. Mingfa, Turbocharged diesel/CNG dual-fuel engines with intercooler: combustion, emissions and performance, SAE 2003 —01—3082, 2003.
- I3. Launder, B.E., and Spalding, DB. 1974. ‘The numerical computation ofturbulent flows’, Comp. Meth. in Appl. Mech. and Eng, 3, pp. 269-289.
- Yayın Aralığı: Yılda 4 Sayı
- Başlangıç: 2008
- Yayıncı: Marmara Üniversitesi