ASSESSING SOUND-MUFFLING CHARACTERISTICS OF FLY-ASH NANO-PARTICLE REINFORCED EPOXY RESIN COMPOSITES

Effective reduction and control of noise have continued to attract attention globally due to the adverse effects noise poses to human health, effective knowledge dissemination and desirable environmental tranquility. The use of natural and synthetic reinforced composites in noise pollution control is an emerging area of research. In this study, coal fly-ash in nanoparticles varied at 5 – 25 wt. % was employed as reinforcement in the fabrication of epoxy resin composites. The composites were characterised both for noise reduction capability and mechanical properties necessary for a damage-free handling during installation. Results showed that at 5 – 15 wt. % fly-ash nanoparticles addition, the composites demonstrated the following mechanical properties in terms of flexural strength, 43.7 MPa; impact energy, 4.8 J and hardness, 25.4 HV. Samples of the composites at 15 wt. % exhibited the highest noise reduction coefficient (NRC) of 0.8072. Contributions to these levels of performances appeared to have stemmed from the nature (connected or isolated) and dispersion of pores induced in the material during mixing and subsequent curing. The composites are adjudged suitable for deployment as noise muffling material in facilities that are usually subjected to low mechanical system noise sources. 

___

  • [1] Harris C. Human Response to Sound. Handbook of Acoustical Measurement and Noise Control. 3rd Edition, McGraw-Hill, 1991.
  • [2] Ogunbowale WO, Banks-lee P, Bello KA, Maiwada S, Kolawole EG. Acoustical absorptive properties of cotton, polylactic acid batts and fabrics. American International Journal of Contemporary Research 2012; 2(11): 9-19.
  • [3] Cox TJ, D'antonio P. Acoustic absorbers and diffusers: theory, design and application. CRC Press, 2nd Edition. USA. 2004.
  • [4] Basner M, Charlotte C, Anna H, Sparrow V. Aviation noise ımpacts: state of the science. Noise and Health 2014; 19(87): 41-50.
  • [5] Peng L, Song B, Wang J, Wang D. Mechanic and acoustic properties of the sound-absorbing material made from natural fiber and polyester. Advances in Materials Science and Engineering 2015; 1-5.
  • [6] Paulo HT, Fernanda F. Assessment of ındoor and outdoor noise pollution at a university hospital based on acoustic measurements and noise mapping. Open Journal of Acoustics 2016; 6: 71-85.
  • [7] Marshall L. Architectural acoustics. 2nd Edition, Academic Press, Oaks, USA. 2014.
  • [8] Srivastava V, Rajeev S. On the polymeric foam: modelling and properties. Journal of Materials Science 2014; 49(7): 2681-2692.
  • [9] Rajappan S, Bhaskaran P, Ravindran P. An ınsight into the composite materials for passive sound absorption. Journal of Applied Sciences 2017; 17: 339-356.
  • [10] Singla M, Chawla V. Mechanical properties of epoxy resin fly-ash composite. Journal of Minerals and Materials Characterization and Engineering 2010; 9(3): 184-199.
  • [11] Bratu M, Ropota I, Vasile O, Dumitrescu O, Muntean M. Sound-absorbing properties of composite materials reinforced with various wastes. Environmental Engineering and Management Journal 2011; 10(8): 1047-1051.
  • [12] Berardi U, Iannace G. Predicting the sound absorption of natural materials: best fit inverse laws for the acoustic impedance and propagation constant. Applied Acoustics 2017; 115: 131-138.
  • [13] Elena V, Natalia A, Leonard A, Alexander G. Fly ash cenospheres: composition, morphology, structure and helium permeability. World of Coal Ash Conference (WOCA), 9-12th May, 2011; Denver, CO, USA.
  • [14] Ward J. Annual coal ash production and use report. Published by the American Coal Ash Association (ACAA), 2015; Mississippi, USA.
  • [15] Arenas C, Leiva C, Luis F, Jose V. Development of acoustic barriers mainly composed of CO-combustion bottom ash. World Coal Ash Conference, 9-12th May, 2011; Denver, CO, USA.
  • [16] Mamtaz H, Fouladi MH, Al-Atabi M, Narayana NS. Acoustic absorption of natural fiber composites. Journal of Engineering 2016; 1-11.
  • [17] Jun CG, Yoon SK, Choi NJ. Application of fly ash as an absorbent for removal of air and water pollutants. Applied Sciences 2018; 8(7): 1116-1125.
  • [18] Jijun T, Zhou H, Yang Z, Zhang J. Properties of graphene oxide/epoxy resin composites. Journal of Nanoparticles 2014; 1-5.
  • [19] Sinval AR, Cesar HZ, Radrigo VC, Demarco FF. Flexural and modulus of elasticity of different types of resin-based composites. Dental Materials 2007; 21(1): 16-21.
  • [20] Leiva C, Arenas C, Vilches LF, Alonso-Fariñas B, Rodriguez-Galán M. Development of fly-ash boards with thermal, acoustic and fire insulation properties. Waste Management 2015; 46: 298- 303.