İbrahim Savaş DALMIŞ, Ümit GÜLER, Alper KARAKOCA, Sait Özmen ERUSLU

AN EXPERIMENTAL AND THEORITICAL STUDY ON THE PRESSURE DROP OF FLUID AT EXTRUSION PROCESS

This paper investigated the pressure drop during the extrusion processes. The objectives of this investigation were to increase efficiency of plastic extrusion which plastic equipment produced. In the experimental processes, two rectangular dies were used. HD 7255 thermoplastic was used as the fluid material of extrusion. A difference occurred between inlet and outlet. This difference was 2.34 MPa in terms of the pressure drop and was 0.001216 (kg s-1) in terms of the flow rate. The results of power law model is found in good agreement with experimental results for outlet sections of process.

___

Baldi, F.; Franceschini, A.; Briatico-Vangosa, F.; Locati, D. and Riccò, T. 2010. Oscillating flow in
capıllary dies for a HDPE melt: effects of extrusion parameters. Int J Mater Form vol. 3 Suppl
:543– 546
Burghelea, T.I.; Griess, H.J. and Münstedt, H. 2010. Comparative investigations of surface
instabilities (“sharkskin”) of a linear and a long-chain branched polyethylene. Journal of Non-
Newtonian Fluid Mechanics, vol. 165, Issues 19–20, pp. 1093–1104
Carneiro, O. S., Nobrega, J. M., Pinho, F. T., Computer aided rheological design of extrusion dies for
profiles, Journal of materials processing technology, 114, pp. 75–86, 2001.
Carneiro, O. S., Nobrega, J. M., Recent developments in automatic die design for profile extrusion,
Plastics Rubber and Composites, 33, pp. 400-408, 2004.
Dubbeldam, J.L.A. and Molenaar, J. 2003. Dynamics of the spurt instability in polymer extrusion. J.
Non-Newtonian Fluid Mech. 112: 217–235
D.M. and Tang, H.S. 2007. Inverse problem solution of squeeze flow for parameters of generalized
Newtonian fluid and wall slip. Journal of Non-Newtonian Fluid Mechanics, 143: 133–140
Ferrás, L.L. Nóbrega, J.M. and Pinho F.T. 2012. Analytical solutions for Newtonian and inelastic non-
Newtonian flows with wall slip. Journal of Non-Newtonian Fluid Mechanics, 175–176: 76–88
Kostic, M. M., Reifschneider, L. G., Design of Extrusion Dies, Encyclopedia of Chemical Processing,
pp. 633-649, 2006.
Mitsoulis, E.; Georgiou, G.C. and Kountouriotis, Z. 2012. A study of various factors affecting Kalyon,
Newtonian extrudate swell. Computers & Fluids, 57: 195–207
Rahimia, S.; Durbanb, D. and Khosid, S. 2010. Wall friction effects and viscosity reduction of gel
propellants in conical extrusion. Journal of Non-Newtonian Fluid Mechanics, 165: 782–792
Xu, X.; Ouyang, J.; Yang, B. and Liu, Z. 2013. SPH simulations of three-dimensional non-Newtonian
free surface flows. Comput. Methods Appl. Mech. Engrg. 256: 101–116