Mineral Katkılı Betonların Mikroyapılarının İncelenmesi
Beton, günümüz dünyasında en çok kullanılan yapı malzemesidir. Üretim metodolojisi ve farklı malzemelerin kullanılması betonun maliyetini etkiler. Bu malzemelerin en önemlisi çimentodur. Çimentoda gerçekleştirilecek düşük maliyet, betonun ekonomik etkinliğini doğrudan etkileyecektir. Mineral katkılar gibi puzolanik malzemeler beton üretiminde çimento ile değiştirilerek kullanılabilir. Bu çalışmada üç farklı puzolanik malzeme (uçucu kül, silis dumanı, yüksek fırın cürufu) %10, %20 ve %30 oranında çimento ile değiştirilmiş ve beton numuneleri üretilmiştir. Numuneler, 7,28 ve 90 gün boyunca laboratuar koşullarında sertleştirildikten sonra basınç dayanımı değerleri ölçülmüştür. En yüksek basınç dayanımı sonuçları %10 silis dumanı ikameli serilerde tespit edilmiştir. Numuneler üzerinde SEM analiz tekniği kullanılarak mikroyapı çalışmaları yapılmış ve mukavemet değerleri ile mikroyapı arasındaki ilişkiler belirlenmeye çalışılmıştır. Uçucu kül ikameli serilerde etrenjit oluşmu gözlenmiştir. Bu durumun basınç dayanım değerlerindeki düşüşe sebep olduğu belirlenmiştir.
Microstructures Investigation of Mineral Additive Concretes
Concrete is the most widely used building materials today's world. Production methodology and using ofdifferent types of materials affect the cost of concrete. The most important of these materials is cement.The low cost to be realized in cement will directly affect the economic efficiency of the concrete.Pozzolanic materials such as mineral admixtures can be used by replacing with cement in concreteproduction. In this study, three different types of pozzolanic materials (fly ash, silica fume, blast furnaceslag) were replaced with cement in %10, %20 and %30 ratios and concrete samples were produced. Thespecimens were tested for compressive strength after curing in laboratory conditions for 7, 28 and 90days. The highest compressive strength data were obtained in 10% silica fume replaced series.Microstructure studies were carried out on the specimens using SEM analysis technique and relationsbetween strength values and microstructures were tried to be established. Ettringite formation wasobserved in fly ash re
___
- Li., Z., 2011. Advanced Concrete Technology,
Published by John Wiley & Sons, Inc.,
Hoboken, New Jersey, 132.
- Mehta, P.K., Monteiro, P.J.M., 2006. Concrete-
Microstructure, Properties and Materials,
McGraw-Hill, Third Edition, 174.
- Topçu, İ.B., 2006. Beton, Uğur Ofset,
Eskişehir, 246.
- Doran, D.K., 2004. Construction Materilas,
Newnes Publishing, 89.
- Neville, A.M., Brooks, J.J., 2010. Concrete
Technology, Pearson Education Limited, UK,
378.
- Kuleli, Ö., 2010. Çimento Mühendisliği El
Kitabı, TÇMB Yayınları, 48.
- Republic of Turkey Ministry of Science,
Industry and Technology. Cement Sector
Report. Industry General Directorate, Sectoral
Reports and Analysis Series. 2015.
- Aprianti, E.S., 2017. A Huge Number of
Artificial
Waste
Material
can
be
Supplementary Cementitious Material (SCM)
for Concrete Production e a Review Part II.
Journal of Cleaner Production 142, 4178-4194.
- Erdoğan, T.Y., 2003. Beton, METU Press. 469.
- ASTM C–618, 1985. Specification for Fly Ash
and Raw or Calcined Natural Pozzolan for use
as a Mineral Admixture in Portland Cement
Concrete.
- Dembosvka, L., Bajare, D., Pundiene, I.,
Vitola, L., 2017. Effect of Pozzolanic
Additives on the Strength Development of
High
Performance
Concrete.
Procedia
Engineering 172, 202-210.
- Baradan, B., Yazıcı, H., Aydın, S., 2015.
Concrete. Dokuz Eylül University Engineering
Faculty Publishing.
- Paiva, H., Silva, A.S., Velosa, A., Cachim, P.,
Ferreira, V.M., 2017. Microstructure and
Hardened State Properties on Pozzolancontaining.
Construction
and
Building
Materials 140, 374–384.
- Shi, C., 1998. Pozzolanic Reaction and
Microstructure of Chemical Activated Lime-fly
Ash Pastes. ACI Materials Journal 95(5),
537-545.
- Wesche, K., 2005. Fly Ash in Concrete. Rilem
Report 7, An Imprint of Chapman & Hall.
- Bapat, J.D., 2013. Mineral Admixtures in
Cement and Concrete. CRC Press Taylor &
Francis Group.
- Ahmaruzzaman, M., 2010. A Review on the
Utilization of Fly Ash. Progress in Energy
Combustion Science, 36, 327-363.
- Aruntaş, H.Y., 2016. Uçucu Küllerin İnşaat
Sektöründe Kullanım Potansiyelleri. Gazi
Üniv. Müh. Mim. Fak. Der. 21, 193-203.
- Tokyay, M., 2016. Cement and Concrete
Mineral Admixtures. CRC Press Taylor &
Francis Group.
- Yeğinobalı, A., 2009. Silis Dumanı ve Çimento
ile Betonda Kullanımı. TCMA Publishing.
- Thomas, M., 2013. Supplementary Cementing
Materilas in Concrete. CRC Press Taylor &
Francis Group.
- Tokyay, M., 2016. Cement and Concrete
Mineral Admixtures. CRC Press Taylor &
Francis Group.
- Tokyay, M., Erdoğdu, K., 2009. Cüruflar ve
Cüruflu Çimentolar. TCMA, Report of Ar-Ge,
8. Edition.
- Canbaz, M., 2007. Alkalilerle Aktive Edilmis
Yüksek Fırın Cüruflu Harçların Özelikleri.
Eskişehir Osmangazi University, PhD Thesis,
244.
- TS EN 197–1i, 2002. Çimentoların Bileşim,
Özellikler ve Uygunluk Kriterleri, Türk
Standartları Enstitüsü, Ankara, (Translation
from Turkish)
- TS EN 1097–6, 2002. Agregaların Mekanik ve
Fiziksel Özellikleri İçin Deneyler, Türk
Standartları Enstitüsü, Ankara, (Translation
from Turkish)
- TS 706 EN 12620, 2009. Beton Agregaları,
Türk
Standartları
Enstitüsü,
Ankara,
(Translation from Turkish)
- TS 802, 2009. Beton Karışım Tasarımı Hesap
Esasları, Türk Standartları Enstitüsü, Ankara,
(Translation from Turkish)
- ASTM C597-09, 2009. Standard Test Method
for Pulse Velocity Through Concrete American
Concrete Institute.
- TS EN 12390-3, 2003. Beton-Sertleşmiş Beton
Deneyleri-Bölüm 3: Deney Numunelerinde
Basınç Dayanımının Tayini, Türk Standartları
Enstitüsü, Ankara. (Translation from Turkish)