TAŞ OCAĞI YER SEÇİMİNDE MÜHENDİSLİK DİSİPLİNİNİN ÖNEMİ: GÖLBAŞI ANDEZİTLERİNDE BİR UYGULAMA

Bu çalışmanın amacı, Ankara ili Gölbaşı ilçesindeki andezitlerde açılmış ocak yerlerinin yerbilimleri açısından uygunluğunu araştırmak, mühendislik disiplini içinde çalışmanın taş ocakçılığı için önemini göstererek büyük maliyetleri ve emek kayıplarını engellemektir. Bu sebeple çalışma yeri olarak, çevresinde rastgele açılmış ve verim alınamadığı için terk edilmiş olduğu düşünülen ocaklar bulunan Hürmat Deresi bölgesi seçilmiştir. Bölgedeki jeolojik yapı ve süreksizlikler yer radarı (GPR) ve sismik kırılma yöntemleri ile incelenmiş, bozunmanın yüksek olduğu yerler ve kırıklar belirlenmiştir. Bulgular, Hürmat deresinin bir fay zonu olduğunu, yüzeyde 10 metreyi bulan bozunmuş ve topraklanmış birim altında yaklaşık 10-11m kırıklı, çatlaklı, verimi düşük olan andezit birimi yer aldığını göstermektedir. Belirlenen en bozunmuş andezit alanında ise bir ocak açıldığı gözlemlenmiştir. Çalışmanın başlangıcında bu ocağın terk edildiği düşünülmüş ancak daha sonraki günlerde ocağın büyütüldüğü görülmüştür. Buradan da Gölbaşı andezit ocakları işletiminin tamamen yerbilimlerinden uzak çalışmalar ile yürütüldüğü, ekonomik kaybın önlenebilmesi için işletmelerin mühendislik disiplini ile çalışması gerekliliği tekrar vurgulanmıştır

The Importance of Engineering Discipline in The Selection of Proper Place for a Quarry: An Application to Gölbaşı Andesites

The aim of this study is to investigate the suitability of the place of Ankara/ Golbasi andesite quarries as earth science’s point of view and to show the importance of engineering discipline which prevents the loss of money and work power in the quarries. For this reason, Hürmat Creek region is selected as the work place as there are quarries which are opened unexceptional and then abandoned because of unproductiveness in the region. The geological structure and the subsurface images of the discontinuities are investigated and the weathered and fractured zones are determined by using the ground penetrating radar (GPR) and seismic refraction method. It is found that, Hürmat creek is a fault zone. There is 6-7 meter weathered and unconsolidated unit. Under this unit, there are fractured, crushed, weathered and uneconomic andesites. It is observed that a quarry was formed at this most weathered part of the region. At first, it was thought that the quarry was abandoned but it was seen later that it was enlarged. This fact highlights that quarrying facilities at the Golbasi andesites are far away from engineering disciplines which are necessary for both quarry owner’s and country’s economy