Valsalal PRASAD, Jayavel RAMASAMY, Kannadasan RAJU

Development of metal oxide arrester block using a rare earth element for very fast transient overvoltage applications

The protection ability of metal oxide arresters against switching, lightning, and steep current surges has been well proven. On the contrary, during the invasion of very fast transients, the existing arrester fails to operate due to delay in its initial response. In order to decrease the delay, it is imperative to improve the electrical properties of the arrester such as nonlinearity and voltage gradient with reduced capacitive effect. In this context, new arrester blocks are developed with the addition of a rare earth element, namely scandium trioxide (Sc 2 O 3 ), and then sintered with a microwave sintering process. Owing to the uniform heat distribution characteristic and the requirement of a low sintering temperature, the microwave sintering process provides better microstructural and electrical properties than the conventional sintering process. From the observed results of prepared arrester blocks, one among them is chosen, which contributes a higher voltage gradient (790 V/mm), better nonlinear coefficient (55), and the least leakage current (2.9 A). Moreover, the chosen arrester block gives a lower block capacitance of 0.0985 nF at 100 Hz. Hence, this arrester block can afford better protection of the power system against very fast transients.

PDF

___

[1] He J, Zeng R, Chen Q, Chen S, Guan Z, Han SW, Cho HG. Nonuniformity of electrical characteristics in mi- crostructures of ZnO surge varistors. IEEE T Power Deliver 2004; 19: 138-144.
[2] Xu D, Tang D, Lin Y, Jiao J, Zhao G, Cheng X. In uence of Yb 2 O 3 doping on microstructural and electrical properties of ZnO{Bi 2 O 3 -based varistor ceramics. J Cent South Univ T 2012; 19: 1497-1502.
[3] Valsalal P, Usa S, Udayakumar K. Importance of capacitance on metal oxide arrester block model for VFTO applications. IEEE T Power Deliver 2011; 26: 1294-1295.
[4] Zhang L, Zhang Q, Liu S, Liu F, Li L, Yin Y, Shi W, Chen W. Insulation characteristics of 1100 kV GIS under very fast transient overvoltage and lightning impulse. IEEE T Dielect El In 2012; 19: 1029-1036.
[5] Valsalal P, Usa S, Udayakumar K. Response of metal oxide arrester in gas-insulated substation and methods to improve its dynamic characteristics. IET Sci Meas Technol 2012; 6: 222-228.
[6] Valsalal P, Usa S, Udayakumar K. Modelling of metal oxide arrester for very fast transients. IET Sci Meas Technol 2011; 5: 140-146.
[7] Valsalal P. Possible measures to enhance the performance of metal{oxide arresters in the EHV network under very fast transients. IEEE T Power Deliver 2015; 30: 783-790.
[8] Kannadasan R, Valsalal P, Jayavel R. Performance improvement of metal oxide arrester for very fast transients. IET Sci Meas Technol 2017; 11: 438-444.
[9] He JL, Hu J, Meng BW, Zhen B, Zhu B, Chen SM, Zeng R. Requirement of ultra-high voltage GIS arrester to voltage gradient of metal-oxide varistor. Sci China Ser E 2009; 52: 450-455.
[10] He JL, Hu J, Lin YH. ZnO varistors with high voltage gradient and low leakage current by doping rare-earth oxide. Sci China Ser E 2008; 51: 693-701.
[11] Shichimiya S, Yamaguchi M, Furuse N, Kobayashi M, Ishibe S. Development of advanced arresters for GIS with new zinc-oxide elements. IEEE T Power Deliver 1998; 13: 465-471.
[12] Zhijian H, Masahide G, Yukio H. Improving sinterability of ceramics using hybrid microwave heating. J Mater Process Tech 2009; 209: 2446-2452.
[13] Ramirez MA, Bueno PR, Longo E, Varela JA. Conventional and microwave sintering of CaCu 3 Ti 4 O 12 /CaTiO 3 ceramic composites: non-ohmic and dielectric properties. J Phys D Appl Phys 2008; 41: 152004.
[14] Zhao J, Wang B, Lu K. In uence of Ta 2 O 5 doping and microwave sintering on TiO 2 -based varistor properties. Ceram Int 2014; 40: 14229-14234.
[15] Lin IN, Lee WC, Liu KS, Cheng HF, Wu MW. On the microwave sintering technology for improving the properties of semiconducting electronic ceramics. J Eur Ceram Soc 2001; 21: 2085-2088.
[16] Savary E, Marinel S, Gascoin F, Kinemuchi Y, Pansiot J, Retoux R. Peculiar effects of microwave sintering on ZnO based varistors properties. J Alloy Compd 2011; 509: 6163-6169.
[17] Tan DQ, Younsi K, Zhou Y, Irwin P, Cao Y. Nano-enabled metal oxide varistors. IEEE T Dielect El In 2009; 16: 934-939.
[18] Kannadasan R, Valsalal P, Jayavel R. High gradient metal oxide surge arrester block for VFTO applications. J Electr Eng 2017; 17: 411-417.