Ali Asil ÖNCELER, Sezai TAŞKIN

MODELING AND ANALYSIS OF SINGLE-PHASE INDUCTION MOTOR DRIVE FOR VARIABLE CAPACITY CONTROL OF A REFRIGERATOR COMPRESSOR

A refrigeration system with single-phase induction motor compressor is used to operate the cooling process at constant speed and On/Off control mode. Using a motor driver with this system allows us to utilize variable speed control algorithms, and gives many opportunities to improve energy efficiency. This paper presents developed model simulation results of a single-phase induction motor drive to improve energy efficiency for a refrigerator compressor motor. For this aim, firstly, a household refrigerator compressor and a compatible drive system are determined to obtain the model of the system. Based on the catalog values of a selected real compressor, a model is created. Then, the developed model simulation results are verified with the real compressor data. In the drive system model, scalar control, single-phase full bridge inverter topology and unipolar sinusoidal pulse width modulation methods are employed. Finally, total harmonic distortion and energy consumption of a single-phase induction motor which is driven by the developed driver model are measured. Energy consumption values of the conventional and variable-speed cooling systems which are available in the market are compared with the developed model.

Keywords:

Single-Phase induction motor, refrigerator compressor motor, energy efficiency, variable frequency driver frequency control, sinusoidal pulse width modulation.,

PDF

___

[1] O.B. Kanargı, Evalution of the performance of a household refrigerator using a variable speed compressor with 1D Simulations, Graduate School of Engineering and Science of İzmir Institute of Technology, MS.c. Thesis in Mechanical Engineering, (2013), 103.
[2] V.E. Agakay, Experimental performance investigation and variable speed compressor implementation of a household refrigerator, Graduate School of Engineering and Science of İzmir Institute of Technology, MS.c. Thesis in Mechanical Engineering, (2013), 87.
[3] R. J. Dossat, T. J. Noran, Principles of refrigeration, Prentice Hall, (1961).
[4] ASHRAE, Handbook - Refrigeration (SI Edition). American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc. (2006).
[5] Y.A. Çengel, M.A. Boles, Thermodynamics: An engineering approach. McGraw-Hill Higher Education. (2005).
[6] O. Ekren, Fuzzy logic control of the compressor speed and electronic expansion valve in a chiller, Dokuz Eylul University, Graduate School of Natural and Applied Sciences, PhD Thesis in Mechanical Engineering, (2009), 143.
[7] T.Q. Qureshi, S.A. Tassou, Variable-speed capacity control in refrigeration systems, Applied Thermal Engineering, 16(2), (1996), 103-113.
[8] S.A. Tassou, R.K. Green, D.R. Wilson, Energy conservation through the use of capacity control in heat pumps, Journal of Inst. Energy, 54, (1981), 30-34.
[9] S.A. Tassou, C.J. Marquand, D.R. Wilson, The effect of capacity modulation on the performance of vapour compression heat pump system, International Syrup. On the Industrial Application of Heat Pumps, UK. (1982).
[10] S.A. Tassou, C.J. Marquand, Y.T. Wang, D.R. Wilson, An economic comparison of a fixed speed, a two speed, and a variable speed vapour compression heat pump, Applied Energy, 16, (1984), 59-66.
[11] S.A. Tassou, Experimental investigation of the dynamic performance of variable-speed heat-pumps, Journal of Inst. Energy. 64, (1991), 95-98.
[12] K. Lida, T. Yamamoto, T. Kuroda, H. Hibi, Development of an energy saving-oriented variable-capacity system heat-pump, ASHRAE Trans. 88, (1982), 441-449.
[13] J.A. McGovern, Performance characteristics of a reciprocating refrigerant compressor over a range of speeds, Proceeding Purdue Compressor Technics Conference, Purdue, (1988), 146-153.
[14] N. Ischii, M. Yamamura, H. Morokoski, M. Fukushima, S.Yamamoto, M. Sakai, On the superior dynamic behaviour of a variable rotating speed scroll compressor, Proceeding of Purdue Compressor Technics Conference, Purdue, (1988), 75-82.
[15] N. Ischii, M. Yamamura, S. Muramatsy, S. Yamamoto, M. Sakai, Mechanical efficiency of a variable speed scroll compressor. Proceeding of Compressor Technics Conference, Purdue, (1990), 192-199.
[16] C.K. Rice, Efficiency characteristics of speed-modulated drives at predicted torque conditions for air-to-air-heat pumps. ASHRAE Trans. 94, (1988), 892 -92.
[17] C.K. Rice, Benchmark performance analysis of an ECM-Modulated air-to-air heat-pump with a reciprocating compressor, ASHRAE Trans. 98, (1992), 430-450.
[18] H. K. Lee, G. Y. Song, J. S. Park, E. P. Hong, W. H. Jung, K.B. Park, Development of the linear compressor for a household refrigerator, (2000). International Compressor Engineering Conference. Paper 1364.
[19] K. Park, E. Hong, H. K. Lee, Linear motor for linear compressor, (2002). International Compressor Engineering Conference. Paper 1544.
[20] Embraco Product Electronic Catalog https://products.embraco.com/products/compressors,(Accessed 05.13.2018).
[21] A.S. Ba-thunya, R. Khopkar, K. Wei, H.A. Toliyat, Single-phase induction motor drives - A Literature survey, Electric Machines and Drives Conference, (2001), Cambridge, USA, 911 – 916.
[22] B. Akin, N. Garg, Scalar (V/f) control of 3-Phase induction motors, Application Report, (2013), Texas Instruments.
[23] A. M. Trzynadlowski, Control of induction motors, Academic Press, (2001), 228.
[24] B.K. Bose, Modern power electronics and AC drives, Prentice-Hall, (2007).
[25] Model dynamics of Single Phase Asynchronous Machine. Mathworks https://www.mathworks.com
[26] C. Blake, C. Bull, IGBT or MOSFET: Choose Wisely, International Rectifier.