NUMERICAL AND EXPERIMENTAL MODELING OF FLOW OVER A BROADCRESTED WEIR

Broad-crested weirs are hydraulic structures installed in open-channels used to control the flow of water and measure the discharge. In this study, the flow over a broad-crested weir in open-channel was experimentally and numerically modeled. Experiments were carried out in a channel with a length of 1.5 m and a width of 0.055 m under five different flow rates. In each experiment, water depth and flow velocity in flow direction were measured using a pitot tube. Numerical model was developed using SimFlow software. The velocities and pressure fields were computed numerically. The water depths and velocities in flow direction obtained from the numerical model were compared to experimental values. There is generally a good agreement between experimental and numerical results. Relatively small errors in velocity profiles are observed in higher discharges.

PDF

___

A. Duru. “Numerical modelling of Contracted sharp crested weirs’’, . Yüksek Lisans Tezi, ODTÜ The Graduate School of Natural and Applied Sciences, Ankara, 2014.

S. Haun, N. Reidar, B. Olsen and R. Feurich, “Numerical modeling of Flow over trapezoidal Broad Crested Weir”, Engineering Applications of Computational Fluid mechanics, Vol. 5, No. 3, 397-405, 2011.

K. Subramanya, Flow in open channel. Tata McGraw-Hill, 7 West Patel Nagar, New Delhi, 547pp, 2009.

R.H. French, Open-channel hydraulics. McGraw-Hill, Singapore, 693 p, 1986.

M. İlkentapar, “Açık kanallarda geniş başlıklı savaklar üzerinden akımın deneysel ve sayısal modellenmesi”, Yüksek Lisans Tezi, EÜ Fen Bilimleri Enstitüsü, İnşaat Mühendisliği Anabilim Dalı, Kayseri, 2015.

H. Chanson, J.S. Montes, “Overflow Characteristics of Circular Weirs: Effect of Inflow Conditions”, Jl of Irrigation and Drainage Engrg, ASCE, Vol. 124, No. 3, 152-162 (ISSN 0733-9437), 1998.

N.G. Soydan, M. S. Aköz, O. Şimşek ve V. Gümüş, “Trapez Kesitli Geniş Başlıklı Savak Akımının k-ε Tabanlı Türbülans Modelleri ile Sayısal Modellenmesi”, Çukurova University Journal of the Faculty of Engineering and Architecture, 27(2), 47- 58, 2012.

T.T. Shih, W.W. Liou, A. Sahbbir, Z. Yang, J. J. Zhu, “A new k-ε eddy viscosity model for high reynolds number turbulent flowsmodel development and validation”, Institute for Computational Mechanics in Propulsion and Center for Modeling of Turbulence and Transition Lewis Research Center, Cleveland, Ohio ,24 (3), 227-238, 1995.

H. Bal, “Geniş başlıklı savak içeren açık kanal akımın sayısal modellenmesi”, Yüksek Lisans Tezi, ÇÜ Fen Bilimleri Enstitüsü, İnşaat Mühendisliği Anabilim Dalı, Adana, 2011.

M. Hamad. “Investigation of flow characteristices through box shape culvet combined with broad crested weir’’, MSc thesis, University of Gaziantep, The Graduate School of Natural and Applied sciences, Gaziantep, 2013.

Anonim, The open source CFD toolbox. https://www.openfoam.com, last accessed: 10.10.2018.