Mermer Ocaklarında Elmas Tel Kesme ve Zincirli Kollu Kesme Makinelerinin Birlikte Kullanımının İncelenmesi

Mermer ocaklarında, elmas tel kesme ve zincirli kollu kesme makineleri, blok üretiminde değişik yöntemlerle kullanılmaktadır. İnceleme yapılan ocakta temel olarak üç farklı üretim şekli uygulanmaktadır. Birincisi Yöntem A olarak adlandırılmış olup standart elmas tel kesme yöntemidir. Bu yöntemde alt, yan ve arka kesimlerin tamamı birbirine dik açılmış deliklerden geçirilen elmas tel yardımıyla gerçekleştirilmektedir. Yöntem B olarak adlandırılan çalışma şeklinde ise arka kesim 7.40 m kol boyuna sahip zincirli kollu kesme makinesi ile kesilirken alt ve yan kesimler elmas teller yardımıyla gerçekleştirilmektedir. Yöntem C yönteminde ise; alt kesim 3.40 m kol boyuna sahip zincirli kollu kesici ile yapılırken yan ve arka kesimler elmas teller yardımıyla gerçekleştirilmektedir. Ocakta uygulanan her üç üretim yöntemi, yaklaşık 4 ay boyunca anlık veriler alınarak değerlendirilmiş olup bu süre zarfında 3848.68 m3 lük bir hacmin kazanılması için toplam 159.60 m delme, 3357.55 m2 kesme işi yapılmıştır. Operasyonlar sırasında makinelerin kullanım şekli, delme/kesme hızları, sarf malzemesi tüketimleri, harcanan iş gücü gibi veriler takip edilmiştir. Sonuç olarak en hızlı yöntemin B yöntemi olduğu, en hızlı kesme makinesinin 7.40 m kol boyuna sahip zincirli kollu kesici olduğu, verimi artırmak için bir defada kesilen alanın en büyük olması gerektiği belirlenmiştir.

Investigation of Using Diamond Wire Cutting and Chain Saw Machines Combination in Quarries

In marble quarries, diamond wire cutting and chain saw machines are used in the process of creating blocks in several ways. Three different cutting techniques were used in the studied quarry. The first one is called Method A which is the standard diamond wire cutting method. In this method; bottom, side and rear cuttings are carried out by diamond wires passing through drilled holes perpendicular to each other. Secondly, the rear is cut with chain saw machine with the length of 7.40m while the bottom and side cuttings are achieved through diamond wires. This is called Method B. The third method, Method C, operates by cutting the bottom with chain saw machine with the length of 3.40m. The side and rear are cut with diamond wire in this method. All three methods operated in the quarry are evaluated with the data taken for approximately 4 months. During this period, 159.60 m drilling and 3357.55 m2 cutting have been done in order to achieve the volume increase of 3848.68 m3. During the operations; the usage of machines, drilling / cutting speed, supplies consumption and labour force are observed and this data is evaluated in terms of production method and type of machinery. As a result of this research, the fastest method was discovered as Method B while the fastest cutting machine was determined as chain saw machine with the length of 7.40m. Moreover; it is found that in order to increase efficiency, areas that are cut must be as large as it can get