Isıl İşlemin Bazı Ağaç Malzemelerin Eğilme ve Basınç Direncine Etkileri

Bu çalışmada sarıçam (Pinus sylvestris L.), doğu kayını (Fagus orientalis L.) ve kara kavak (Populusnigra L.) odunlarından elde edilen örnekler 130, 165 ve 200 ºC’de 2, 6 ve 10 saat süre ile ısıl işleme maruz bırakıldıktan sonra örnekler üzerinde TS 2474 esaslarına uygun olarak eğilme ve TS 2595 esaslarına uygun olarak liflere paralel basınç direnci uygulanmıştır.Deney sonucunda, ısıl işlem süresine ve sıcaklık miktarının artmasına bağlı olarak ağaç malzemenin rengi koyulaşırken basınç direncinde en yüksek değer kontrol kayın örneklerinde 70.94 (N/mm2) olarak elde edilirken en küçük değer ise 200 ºC’de 10 saat ısıl işlem uygulanmış kavak odununda 37,09 (N/mm2) olarak elde edilmiştir. Eğilme direncinde de, en yüksek eğilme direnci değeri kontrol kayın odununda 105,7 (N/mm2) olarak bulunurken en düşük eğilme direnci 10 saat süre ile ısıl işleme tabi tutulan kavak odununda 49,17 (N/mm2) olarak tespit edilmiştir. Bu sonuçlardan yola çıkarak ısıl işlemin süresi ve sıcaklığı arttıkça eğilme ve basınç değerlerinde belli oranlarda kayıpların yaşandığı söylenebilir.

Effects of Heat Treatment on Bending and Compression Strengthes of Some Wood

In this study, After Scots pine (Pinus sylvestris L.), oriantal beech (Fagus orientalis L.) and black poplar (PopulusnigraL.) were heat-treated for 2 hours, 6 hours and 10 hours at130ºC, 165ºC and 200 ºC, bending and compression tests were carriedout according to the TS 2474 and the TS 2595.Experimental results, as depending on the heat treatment time and temperature, increase the wood the colorof the dark. While highest pressure resistance the value controls beech samples 70.94 (N/mm2) was obtained, thelowest value and 200 ° C, 10 h heat treated poplar wood in the 37,09 (N/mm2) was obtained. In addition to, highestbending strenght controls beech samples105,7 (N/mm2) was obtain, lowest value and 200 ° C, 10 h heat treatedpoplar wood in the 49,17 (N/mm2) was obtained. Based on this results, increas of heat treatment time andtemperature, values of on the bending and pressure strenght can be said