HSS Torna Kalemindeki Talaş Açısının Kesme Kuvvetlerine Etkisi

Bu çalışmada, torna kalemlerindeki talaş açısı ve talaş derinliğinin kesme kuvvetlerine etkileri deneysel olarak incelenmiştir. Deneylerde 3°, 7° ve 12°’lik farklı talaş açılarında bilenmiş HSS torna kalemleri ile AISI 1040 çelik malzeme kullanılmıştır. Kesme işlemleri için; 40m/min kesme hızı (Vc), 0.2 mm/dev ilerleme (s) ile talaş derinliği her talaş açısına bağlı olarak 1mm, 1.5mm ve 2mm alınmıştır. Kesme işlemi sonucunda oluşan kuvvetler; Fc (esas kesme kuvveti), Ff (ilerleme kuvveti) ve Fp (radyal kuvvet) piezoelektrik KISTLER 9257B üç bileşenli dinamometre yardımıyla ölçülmüştür. Deney sınırları içersinde en küçük esas kesme kuvveti olan 486.6 N değeri 12°’lik talaş açısı ve 1mm talaş derinliğinde, en yüksek esas kesme kuvvet olan 1042.98 N değeri ise 3°’lik talaş açısı ve 2mm talaş derinliğinde elde edilmiştir.

The Effect of Rake Angle on Cutting Forces in HSS Lathe Cutting Tool

In this study, the effects of rake angle of the lathe cutting tool on the cutting and feed force were experimentally investigated. In cutting experiment, HSS cutting tools grinded in three different rake angles (e.g. 3°, 7° and 12°) and AISI 1040 steel materials were used. For each cutting process, cutting velocity and feed were set to 40 m/min and 0.2 mm/cycle, respectively. Meanwhile, the depths of cut were taken as 1 mm, 1.5 mm and 2 mm depending on each rake angles. In experiments, the tangential (Fc), feed (Ff) and radial (Fp) forces were measured by using a Kistler 9257B type three component piezoelectric dynamometer. It is obtained that in the limits of the experiment the lowest main cutting force of 486.6 N was at a rake angle of 12° and a depth of cut 1 mm while the highest main cutting force of 1042 N was at an angle of 3° and a depth of cut 2 mm
Politeknik Dergisi-Cover
  • ISSN: 1302-0900
  • Yayın Aralığı: Yılda 4 Sayı
  • Başlangıç: 1998
  • Yayıncı: GAZİ ÜNİVERSİTESİ