AKTİF KARBON-POLİVİNİL ALKOL KOMPOZİT KÜRECİKLERİ İLE SENTETİK ATIKSUDAN CR(VI) GİDERİMİ

In this study, composite carbon beads were prepared at different mass ratios of powdered activated carbon, polyvinyl alcohol and glutaraldehyde. The beads were used as adsorbent in Cr(VI) removal from synthetic wastewater. The surface area of the synthesized beads were analyzed by N2 adsorption (BET) and pore structure was visualized by scanning electron microscopy. Cr (VI) adsorption experiments were conducted at room temperature under conditions of 5 g.l-1 adsorbent dose, pH 3.0 and 120 rpm shaking rate. Results showed that, depending on composition, composite beads were 1.4-2.1 times more effective in Cr(VI) removal with respect to raw activated carbon whose Cr(VI) removal capacity and extent were determined as 3.61 mg.g-1 and 18%, respectively. The enhanced efficacy of Cr(VI) removal was attributed to the increase in the number of hydroxylic functional groups as well as the change in pore size distribution.

-

In this study, composite carbon beads were prepared at different mass ratios of powdered activated carbon, polyvinyl alcohol and glutaraldehyde. The beads were used as adsorbent in Cr(VI) removal from synthetic wastewater. The surface area of the synthesized beads were analyzed by N2 adsorption (BET) and pore structure was visualized by scanning electron microscopy. Cr (VI) adsorption experiments were conducted at room temperature under conditions of 5 g.l-1 adsorbent dose, pH 3.0 and 120 rpm shaking rate. Results showed that, depending on composition, composite beads were 1.4-2.1 times more effective in Cr(VI) removal with respect to raw activated carbon whose Cr(VI) removal capacity and extent were determined as 3.61 mg.g-1 and 18%, respectively. The enhanced efficacy of Cr(VI) removal was attributed to the increase in the number of hydroxylic functional groups as well as the change in pore size distribution

___

  • Abechi, S.E., C.E. Gimba, C.E. Uzairu, A. and Dallatu, Y.A. (2013). Preparation and Characterization of Activated Carbon from Palm Kernel Shell by Chemical Activation, Research Journal of Chemical Sciences 3(7), 54-61.
  • Aggarwal, D., Goyal, M. and Bansal, R.C. (1999). Adsorption of Chromium by Activated Carbon from Aqueous Solution, Carbon 37(12), 1989-1997.
  • Babel, S. and Kurniawan, T.A. (2004). Cr(VI) Removal from Synthetic Wastewater using Coconut Shell Charcoal and Commercial Activated Carbon Modified with Oxidizing Agents and/or Chitosan, Chemosphere 54(7), 951-967.
  • Chang,Y. H., Hsieh,K. H. and Chang F.C. (2009). Removal of Hg2+from Aqueous Solution using a Novel Composite Carbon Adsorbent, Journal of Applied Polymer Science 112 (4), 2445-2454.
  • Chingombe, P., Saha, B. and Wakeman, R.J. (2005). Surface Modification and Characterisation of a Coal-Based Activated Carbon, Carbon 43(15), 3132-3143.
  • Choi, H. D., Cho, J. M., Baek, K., Yang, J. S. and Lee, J. Y. (2009). Influence of Cationic Surfactant on Adsorption of Cr(VI) onto Activated Carbon, Journal of Hazardous Materials 161(2-3), 1565- 1568.
  • Costa, V.C., Costa, H.S., Vasconcelos, W.L., Pereira, M.M.O., Rodrigo, L. and Mansur, H.S. (2007) Preparation of Hybrid Biomaterials for Bone Tissue Engineering, Materials Research 10(1), 21- 26, doi:10.1590/S1516-14392007000100006.
  • Khezami, L. and Capart, R. (2005). Removal of chromium(VI) from Aqueous Solution by Activated Carbons: Kinetic and Equilibrium Studies, Journal of Hazardous Materials 123(1-3), 223-231.
  • Mohan, D. and Pittman Jr., C.U. (2006) Activated carbons and low cost adsorbents for remediation of tri- and hexavalent chromium from water, Journal of Hazardous Materials B137(2), 762-811.
  • Mohan, D., Singh, K. and Singh, V. (2005). Removal of Hexavalent Chromium from Aqueous Solution using Low-cost Activated Carbons Derived from Agricultural waste Materials and Activated Carbon Fabric Cloth, Industrial Engineering Chemistry Research 44(4), 1027-1042.
  • Monser, L. and Adhoum, N. (2002). Modified Activated Carbon for The Removal of Copper, Zinc, Chromium and Cyanide from Wastewater, Separation and Purification Technology 26(2-3), 137- 146.
  • Owlad, M., Aroua, M.K., Daud, W.A.W. and Baroutian, S. (2009). Removal of Hexavalent Chromium Contaminated Water and Wastewater: A Review, Water Air and Soil Pollution 200(1-4), 59-77.
  • Park, S. J. and Jang, Y. S. (2002). Pore Structure and Surface Properties of Chemically Modified Activated Carbons for Adsorption Mechanism and Rate of Cr(VI), Journal of Colloid and Interface Science 249(2), 458-463.
  • Rao, R.A.K, Ikram, S. and Ahmad, J. (2011). Adsorption of Pb(II) on A Composite Material Prepared from polystYrene-Alumina and Activated Carbon: Kinetic and Thermodynamic Studies, Journal of the Iranian Chemical Society 8(4), 931-943.
  • Singha, S., Sarkar, U. and Luharuka, P. (2013). Functionalized Granular Activated Carbon and Surface Complexation with Chromates and Bi-chromates in Wastewater, Science of the Total Environment 447, 472-487.
  • Su Kirliliği Kontrolü Yönetmeliği: 2004, www.mevzuat.adalet.gov.tr/html/23053.html.
  • Sun, Y., Yue, Q., Gao, B., Gao, Y., Li, Q. and Wang, Y. (2013). Adsorption of Hexavalent Chromium on Arundo Donax Linn Activated Carbon Amine-crosslinked Copolymer, Chemical Engineering Journal 217, 240-247.
  • Zhang D., Ma, Y., Feng, H., Wang, Y. and Hao, Y. (2012). Preparation and Characterization of The Carbon–microsilica Composite Sorbent, Advanced Powder Technology 23(2), 215-219.
  • Zhao, N., Wei, N., Li, J., Qiao, Z., Cui, J. and He, F. (2005). Surface Properties of Chemically Modified Activated Carbons for Adsorption Rate of Cr (VI), Chemical Engineering Journal 115(1-2), 133- 138.
  • Zhu, S., Yang, N. and Zhang, D. (2009). Poly(N,N-dimethylaminoethyl methacrylate) Modification of Activated Carbon for Copper Ions Removal, Materials Chemistry and Physics 113(2-3), 784-789.
Eskişehir Technical University Journal of Science and Technology A - Applied Sciences and Engineering-Cover
  • ISSN: 2667-4211
  • Yayın Aralığı: Yılda 4 Sayı
  • Başlangıç: 2000
  • Yayıncı: Eskişehir Teknik Üniversitesi
Sayıdaki Diğer Makaleler

YAŞ TUĞLA KURUTMA PARAMETRELERİNİN DENEYSEL OLARAK İNCELENMESİ

Ebru MANCUHAN, Selin ÖZEN, Perviz SAYAN, Sibel TİTİZ SARGUT, Gamze CİĞER, Buğçe ÖZOĞUL

ELEKTROKOAGÜLASYON YÖNTEMİYLE KAĞIT ATIK SUYU ARITIMINDA pH KONTROLU

Şule Camcıoğlu, Baran Ozyurt, Hale Hapoglu

KESTANE KABUĞUNUN PİROLİZİ VE ELDE EDİLEN ÜRÜNLERİN KARAKTERİZASYONU

İlknur DEMIRAL, Şerife ÇEMREK KUL

ÇEŞİTLİ ALÇILARDA TOLUENİN DİFÜZYON VE ADSORPSİYONUNUN DİNAMİK ANALİZİ

Şakir Yılmaz, Mehmet Kalender, Cevdet Akosman

BASIC RED 46 BOYAR MADDESİNİN MONTMORİLLONİTLİ KİREÇ TAŞINA ADSORBSİYONU

Deniz UZUNOĞLU, Ayla ÖZER, Zeynep ÖZDEMİR

MİKROELEKTROLİZ YÖNTEMİ İLE MODEL ÇÖZELTİDEN REAKTİF BLACK 5 GİDERİMİ

Belgin KARABACAKOĞLU, İbrahim ZURNACI, Fatma MEMİŞ, Kıvanç KAYA, Yeşim ÖZTAYLAN

GLUCONACETOBACTER HANSENİİ P2A İLE GERÇEKLEŞTİRİLEN BAKTERİYEL SELÜLOZ ÜRETİMİNİN KİNETİK MODELLENMESİ

Yasar AYDIN, Nuran DEVECİ AKSOY

ULTRASES YARDIMIYLA ALKALİ EMDİRİLEREK HAZIRLANMIŞ AKTİF KARBONLARIN YÜZEY ALANLARININ MODELLENMESİ VE OPTİMİZASYONU

Enes ŞAYAN, Aytaç İNGEÇ

ELEKTROSPİNNİNG PARAMETRELERİNİN JELATİN/BİYOAKTİF CAM NANOLİF YAPISI ÜZERİNDEKİ ETKİLERİNİN İNCELENMESİ

Seza GÖNEN, Bade ERTÜRK, Ece TÜCCAR, Melek EROL TAYGUN, Sadriye KÜÇÜKBAYRAK

ACID BLUE 121 BOYAR MADDESİNİN MUZ KABUĞUNA KESİKLİ SİSTEMDE ADSORBSİYONUNUN ARAŞTIRILMASI

Deniz UZUNOĞLU, Ayla ÖZER, Ahmet USLU, Onur ELBAĞLI, Yakup ŞEN