Prefarbik yapı elemanı üretiminde kullanılan çelik kalıpların titreşim etkisinde teorik ve deneysel olarak incelenmesi

Prefabrik yapı elemanı üretiminde kullanılan vibrator tip ve konumunun deneme-yanılma yöntemi ile belirlenmesi zaman kaybına yol açmakla ve her zaman en iyi sonucu vermemektedir. Bu nedenle bilgisayar destekli kalıp tasarımına ihtiyaç duyulmaktadır. Bu çalışmada, bilgisayar destekli kalıp tasarımına bir temel teşkil etmek üzere, Kambeton Firmasında üretimde kullanılan bazı kalıpların titreşim özellikleri deneysel ve teorik olarak incelenmiştir. Deneysel kısmı, prefabrik yapı elemanına ait kalıp üzerinde seçilen bazı noktalarda yapılmıştır. Teorik kısmı ise, SAP2000® yazılımı kullanılarak, Sonlu Elemanlar Yöntemi ile gerçekleştirilmiştir. Zaman Tanım Alanında analiz, Mod Birleştirme Yöntemi ile, Özvektörler ve Ritz-vektörleri kullanılarak yapılmıştır. Teorik ve deneysel deplasman değerleri karşılaştırılmıştır.

Theoretical and experimental investigation of steel moulds used in the production of precast concrete units under vibration

The determination of the type and location of the vibrators used in the production of precast concrete units with the method of trial and error leads to losing time and doesn't yield the best result. Therefore, the computer-aided mould design is required. In this study, the properties of vibration of some moulds used in the production of Kambeton Company were investigated experimentally and theoretically to establish a base for the computer-aided mould design. The experimental part was performed at some points selected on the mould of precast concrete members. The theoretical part was realized employing Finite Element Method used in SAP2000® software. Time History analysis was carried out by mode-superposition method, in which load-dependent Rits vectors and Eigenvectors were used. The computational results of displacement histories were compared with the experimental ones.

___

  • 1.Wenzel,D., "Compaction of concrete-principles, practice, special problems". Betonwerk und Fertigteil - Technik, 52 (3), 153-158, 1986.
  • 2.Wilson,E.L., Yuan,M.W. and Dickens,J.M., "Dynamic Analysis by Direct Superposition of Ritz Vectors", Earthquake Eng. and Structural Dynamics, 10, 813-823, 1982.
  • 3.SAP2000®,"Integrated Finite Element Analysis and Design of Structures", Computers and Structures, Inc., Berkeley, California, USA, 1999.