Fotovoltaik Güneş Panellerinin Sıvıya Daldırma Yöntemi ile Soğutulmasında Kanal Geometrisi ve Panel Konumunun Etkisi

Güneş enerjisinden elektrik enerjisi üreten sistemlerde fotovoltaik hücrelerin soğutulması sistem verimini artırmaktadır. Bu hücrelerin soğutulması için birçok yöntem ve parametre mevcuttur. Bu çalışmada alt yüzeyinde kanatçıklar bulunan fotovoltaik güneş panelinin dielektrik sıvıya daldırma yöntemi ile soğutulmasında soğutma kanalı geometrisi ve panel konumunun fotovoltaik hücre sıcaklıklarına etkisi sayısal olarak incelenmiştir. Sayısal analizler kanal çıkış genişliği, panelin eksenel ve radyal yöndeki konumu parametreleri için gerçekleştirilmiştir. Ayrıca, parametre değerlerinin değişimi ile oluşan ek basınç kayıpları hesaplanarak soğutma için gerekli enerji gereksinimi ortaya konulmuştur. Analizler sonucunda kanal çıkışının daraltılması ve panelin eksenel konumunun kanal çıkışına yakın olması durumunda fotovoltaik hücreler için daha etkin soğutma sağlandığı gözlemlenmiştir. Sayısal çalışma sırasında elde edilen bulgular sıcaklık, basınç değişimi, hız ve sıcaklık kontörlerini içeren grafikler halinde ayrıntılı olarak sunulmuştur

Effect of Channel Geometry and Panel Position at Cooling of Photovoltaic Solar Panels with Liquid Immersion Method

Today, energy consumption have increased significantly because of developed technology. Therefore, using of fossil fuels have increased step by step. All of these have caused increasing of renewable energy sources and sustainable energy researches. In this study, the effect of cooling channel geometry and panel position on the temperature of photovoltaic cells are investigated at cooling of the photovoltaic solar panel that has fins on its bottom surface, with liquid immersion cooling method, numerically. Numerical analyses are carried out for parameters of channel outlet width, axial and radial position of the panel. Also, additional pressure losses that occurred with variation of parameter values are calculated and energy requirement is introduced for cooling. In consequence of analyses, it is observed that more effective cooling is provided in the case of narrowing of the channel outlet and panel position is close to channel outlet. Findings obtained during the numerical study are presented as graphics that include temperature, variation of pressure, and velocity contours in detail.

___

1.Royne,A.,Dey, C.J.,Mills,D.R.,2005. Cooling of Photovoltaic Cells under Concentrated Illumination: A CriticalReview, Sol. Energy Mater. Sol. Cells, vol. 86, no. 4, pp. 451-483.

2.Liu, L.,Zhu, L.,Wang, Y., Huang, Q., Sun, Y., Yin, Z.,2011. Heat Dissipation Performance of Silicon Solar Cells by Direct Dielectric Liquid Immersion under Intensified Illuminations, Sol. Energy, vol. 85, no. 5, pp. 922-930.

3.Zhu, L.,Boehm, R.F.,Wang, Y., Halford, C., Sun,Y., 2011. Water Immersion Cooling of PV Cells in a High Concentration System, Sol. Energy Mater. Sol. Cells, vol. 95, no. 2, pp. 538-545.

4.Sheeba, K.N.,Rao, R.M.,Jaisankar, S.,2015. A Study on the Underwater Performance of a Solar Photovoltaic Panel, Energy Sources, Part A Recover. Util. Environ. Eff., vol. 37, no. 14, pp. 1505-1512.

5.Florschuetz, L.W., Truman, C.R., Metzger,D.E., 1981. Streamwise Flow and Heat Transfer Distributions for Jet Array Impingement with Crossflow, J. Heat Transfer, vol. 103, no. 2, p.337.

6.Min, C.,Nuofu, C., Xiaoli, Y.,Yu, W.,Yiming, B.,Xingwang, Z.,2009. Thermal Analysis and Test for Single Concentrator Solar Cells, J. Semicond., Chinese Institute of Electronics,vol. 30, no. 4.

7.Natarajan, S.K., Mallick, T.K., Katz, M.,Weingaertner, S.,2011. Numerical Investigations of Solar Cell Temperature for Photovoltaic Concentrator System with and Without Passive Cooling Arrangements, Int. J. Therm. Sci., vol. 50, no. 12, pp. 2514-2521.

8.Coventry, J.S.,2005. Performance of a Concentrating Photovoltaic/thermal Solar Collector, Sol. Energy, vol. 78, no. 2, pp.211-222.

9.Sun, Y.,Wang, Y., Zhu, L., Huang, Q.,Xiang, H.,2016. Simulation Study of a Linear Concentrating Photovoltaic Receiver with Direct Liquid-Immersed Solar Cells, Sol. Energy, vol. 124, pp. 1-14.

10.Xiang, H.,Wang, Y., Zhu, L.,Han, X.,Sun, Y.,Zhao, Z.,2012. 3D Numerical Simulation on Heat Transfer Performance of a Cylindrical Liquid Immersion Solar Receiver, Energy Convers. Manag., vol. 64, pp. 97-105.
Çukurova Üniversitesi Mühendislik-Mimarlik Fakültesi Dergisi-Cover
  • ISSN: 1019-1011
  • Yayın Aralığı: Yılda 4 Sayı
  • Başlangıç: 1986
  • Yayıncı: ÇUKUROVA ÜNİVERSİTESİ MÜHENDİSLİK FAKÜLTESİ
Sayıdaki Diğer Makaleler

New Regression Models for Predicting the Hamstring Muscle Strength using Support Vector Machines

Boubacar SOW, Mehmet Fatih AKAY, FATİH ABUT, Ebru ÇETİN, İmdat YARIM, Hacer ALAK

Temiz Suya Ulaşmada Bina İçi Su Yapıları Üzerine Halktaki Farkındalık ve Bilincin Ölçülmesi

ROZELİN AYDIN, Yağmur ATAKAV, SEDA CEYLAN

Cam Elyaf Kompozitlerin Alüminyum Plaka ile Yapıştırılması ve Yapışmanın Mekanik Özelliklerinin Araştırılması

M Veysel ÇAKIR, Didem KINAY

API 5L X65 Çeliklerinin MAG Kaynak Yöntemi ile Birleştirilmesinde, Kaynak İşleminin Mikroyapı ve Mekanik Özelliklere Etkisinin İncelenmesi

HAKAN ADA, SİNAN AKSÖZ, TAYFUN FINDIK, Cemil ÇETİNKAYA, BÜLENT BOSTAN, İlhan CANDAN

Design of the Dual-Wideband Monopole Antenna for UMTS, WLAN and WiMAX Applications by using a Novel Hybrid Optimization Algorithm

DENİZ ÜSTÜN, Ali AKDAĞLI

Casting the Swarms Problem in the Ensembles Context

Çağatay KOK, Seven Burçin ÇELLEK, Çağlar KOŞUN, Serhan ÖZDEMİR

Gemilerdeki Kaynaklı Yapılarda Isı Yalıtımı

Mehmet ŞAHİN, YAHYA BOZKURT

Pull out Performance of Medical Screws used in Orthopaedic Surgeries

Durmuş Ali BİRCAN, Ahmet ÇETİN

Tamamlayıcı Fonksiyonlar Yöntemi ile Heterojen Bir Çubuğun Zorlanmış Titreşim Analizi

KERİMCAN ÇELEBİ, DURMUŞ YARIMPABUÇ, MEHMET EKER

Experimental Investigation of Low-Velocity Impact Response of Plain-Weave Glass/Epoxy Composites Reinforced with Carbon Nanotubes

GÜLŞAH ÖNER, Hasan Yavuz ÜNAL, Yeliz PEKBEY