MAGNEZYUM DİBORÜR TELLERİN MİKRO YAPISI VE GERİLME ANALİZİ - MICROSTRUCTURE AND STRESS ANALYSIS OF THE MAGNESIUM DIBORIDE WIRES

MAGNEZYUM DİBORÜR TELLERİN MİKRO YAPISI VE GERİLME ANALİZİ Bu çalışmada, ısıl işlem prosesinin süperiletken Magnezyum Diborür tellerin mikro yapısına ve oluşan gerilme dağılımlarına etkisi incelenmektedir. Sürekli Tüp Biçimlendirme ve Doldurma (CTFF) prosesi ile farklı çaplarda üretilen süperiletken Bakır/Magnezyum Diborür tellerin mikro yapısı Taramalı Elektrom Mikroskopu(SEM) ve Enerji Dağılım Spektroskopisi (EDS) kullanılarak karakterize edilmektedir ve gerilme dağılımı hesapları analitik olarak hesaplanmıştır. Bu çalışmada, Bakır/Magnezyum Diborür tellerin ara bölgesinde gerilme değerlerininmaksimum değerde olduğu görülmektedir.MICROSTRUCTURE AND STRESS ANALYSIS OF THE MAGNESIUM DIBORIDE WIRESIn this study, the effect of the annealing process on the microstructure and the stress distribution of the Magnesium Diboride wires were investigated. The presented microstructure properties of the Copper/Magnesium Diboride wires are characterized for the varous diameters fabricated by the Continuous Tube Forming and Filling (CTFF) by using Scanning Electron Microscopy (SEM) and Electron Dispersive Spectroscopy (EDS) and the stress distribution is calculated analytically. In this study, it is observed that values of stress components are maximum at the interface region of Copper/Magnesium Diboride wires.

-

In this study, the effect of the annealing process on the microstructure and the stress distribution of the Magnesium Diboride wires were investigated. The presented microstructure properties of the Copper/Magnesium Diboride wires are characterized for the varous diameters fabricated by the Continuous Tube Forming and Filling (CTFF) by using Scanning Electron Microscopy (SEM) and Electron Dispersive Spectroscopy (EDS) and the stress distribution is calculated analytically. In this study, it is observed that values of stress components are maximum at the interface region of Copper/Magnesium Diboride wires
Keywords:

-,

___

  • Sumption, M.D., Bhatia, M., Buta, F., Bohnenstiehl, S., Tomsic, M. , Rindfleisch, M., Yue, J., Phillips, J. , Kawabata, S., Collings, E.W., “Solenoidal coils made from MgB2 strands,” Supercond. Sci. Technol. c.18, s. 961– 965, 2005. and multifilamentary
  • Sumption, M. D., Bhatia, M., Buta, F., Bohnenstiehl, S., Tomsic, M., Rindfleisch, M., Yue, J., Phillips, J., Kawabata, Multifilamentary MgB2-based solenoidal and racetrack coils, Physica C, c. 458, s.12-20. E. W. (2007).
  • Sumption, M.D., Bohnenstiehl, S., Buta, F., Majoros, M., Kawabata, S., Tomsic, M., Rindfleisch, M., Phillips, J., Yue, J., Collings, E.W., “Wind and React and React and Wind MgB2 Solenoid, Racetrack and Pancake Coils,” IEEE Trans. Appl. Super. c. 17, s. 2286–2290, 2007.
  • Sumption, M.D., Bhatia, M., Rindfleisch, M., Phillips, J., Tomsic, M., Collings, E.W., “MgB2/Cu racetrack coil winding, insulating, and testing,” IEEE Trans. Appl. Superconduct. c. 15, s. 1457–1460, 2005.
  • Arda, L., Sacli, O.A., Tomsic, M., Dur, O., Hascicek, Y.S., “Field dependence of the critical current density of MgB2/Cu wire for coil development,” Supercond. Sci. Technol. c.20, s. 1054–1058, 2007.
  • Kawagoe, A., Matsushima, K., Yoshidome, Y., Kawabata, S., Sumiyoshi, F., Yanagi, N., Mito, T., Kuichi, M., Otabe, E. S., Matsushita, T., Tanaka, K., ve Wakuda, T. (2011). Development of an MgB2 Coil
  • Wound With a Parallel Conductor Composed of Two Tapes With Insulation. IEEE Trans. on Appl. Super., c. 21, s.1612-1615.
  • Kitaguchi, H., Kumakura, H. ve Togano, K. (2011).
  • Strain effect in MgB2/stainless steel superconducting tape. Physica C, c. 363, s. 198-201. Arda, L., Ataoglu, S., Sezer, S. ve Abdulaliyev, Z. (2007). Residual stress analysis of multi-layered buffer layers on Ni substrate for YBCO coated conductor. Surf. Coat. Tech., c. 202, s. 439–446.
  • Sumption, M. D., Bhatia, M., Dou, S. X., Rindfliesh, M., Tomsic, M., Arda, L., Ozdemir, M., Hascicek, Y. S. ve Collings, E. W. (2004). Irreversibility field and flux pinning in MgB2 with and without SiC additions,
  • Supercond. Sci. Technol, c.17, s. 1180-1184.
  • Aslanoglu, Z., Arda, L., Akin, Y., Hascicek, Y. S., Sumption, Characterization ve MgB2 development. Advences in Cryogenic Engineering Materials, c. 50 B, s. 533-540. Tomsic, M. (2004). conductors for coil
  • Timoshenko S. P., Goodier, J. N. (1970). Theory of elasticity, McGraw-Hill, New York.
  • Yu, Y. H., Lai, M. O., Lu, L. ve Yang, P. (2008).
  • Measurement of residual stress of PZT thin film on Si(1 0 0) by synchrotron X-ray rocking curve technique, J. Alloy. Compound, c. 449, s. 556-59. Arda, L., Ataoglu, S., Abdulaliyev, Z. ve Sacli, O. A. (2009). Stress analysis of ceramic insulation coating on Cu/MgB2 wires for W&R MgB2 coils. J.Alloy Compound, c. 470, s. 404-407.
  • Geliş Tarihi: 16.12.2013 Kabul Tarihi: 14.07.2014

___

Bibtex
APA Dönmez, A. & Ataoğlu, Ş. (). . , 10 (2) , 73-77 . DOI: 10.18466/cbufbe.42549
MLA Dönmez, A. , Ataoğlu, Ş. "" . 10 ( ): 73-77 <
Chicago Dönmez, A. , Ataoğlu, Ş. "". 10 ( ): 73-77
RIS TY - JOUR T1 - MAGNEZYUM DİBORÜR TELLERİN MİKRO YAPISI VE GERİLME ANALİZİ - MICROSTRUCTURE AND STRESS ANALYSIS OF THE MAGNESIUM DIBORIDE WIRES AU - AbdullahDönmez, ŞenolAtaoğlu Y1 - 2015 PY - 2015 N1 - doi: 10.18466/cbufbe.42549 DO - 10.18466/cbufbe.42549 T2 - Celal Bayar University Journal of Science JF - Journal JO - JOR SP - 73 EP - 77 VL - 10 IS - 2 SN - 1305-130X-1305-1385 M3 - doi: 10.18466/cbufbe.42549 UR - Y2 - 2022 ER -
EndNote %0 Celal Bayar Üniversitesi Fen Bilimleri Dergisi %A Abdullah Dönmez , Şenol Ataoğlu %T %D 2015 %J Celal Bayar University Journal of Science %P 1305-130X-1305-1385 %V 10 %N 2 %R doi: 10.18466/cbufbe.42549 %U 10.18466/cbufbe.42549
ISNAD Dönmez, Abdullah , Ataoğlu, Şenol . "". Celal Bayar University Journal of Science 10 / 2 (Ocak 2015): 73-77 .
AMA Dönmez A. , Ataoğlu Ş. . CBUJOS. 2015; 10(2): 73-77.
Vancouver Dönmez A. , Ataoğlu Ş. . Celal Bayar University Journal of Science. 2015; 10(2): 73-77.
IEEE A. Dönmez ve Ş. Ataoğlu , "", , c. 10, sayı. 2, ss. 73-77, Oca. 2015, doi:10.18466/cbufbe.42549